Search results

Hi, I have 12v at F7 but am unsure about the location of the blower relay C153. There's 0volts on the brown lead going into the connector C431 (which I originally connected to the battery) I presume this fits into CO 15. I can't see C647, C901 or C056. I've attached photos of it all - a bit...

Re first reply - the key fob didn't work until I pressed the inertia switch, then it all returned to normal. My Haynes wiring diagram for models WITHOUT AIRCON (mine has) shows a lead colour w/r from F7 to the heater control system. Can I apply a live feed to this & bypass the fusebox? I also...

The heater fan on my 02 TD5 is not working. The fuse is ok. I searched online for advice & found this...

Hi I bit on the bullet & bought a used box & torque converter off ebay from jbs4x4 100% +ve feedback & lots of testimonials - total cost with fitting £850 - problem solved - so far so good! Fingers x'd.

Diagnostics showed no faults in the geabox so I've had the oil & filter changed. There was some dark grey sludge in the gearbox pan. it could be seen in the filter port & the drained oil (approx 3.5 lt) is also black. The replaced oil level was checked 4 times by going through the gear range...

Thanks -I'll take it to my L/R guys in the morning for tests.

Thanks - how do I tell if it's EU3?If it is what does unplugging it tell us?

Thanks- done that - revs peaked at 2800 for 3 secs, so the TC & clutch are both ok?

Thanks. I'm wondering why it has taken 4 months for the problem to develop, folllowing the repeated oil losses in the autumn. I'll start looking for a used box.

Filter & oil were changed a year ago. The local L/R specialist I use advised against a further oil & filter change as they thought that would dislodge more muck.

Last autumn the oil cooler started leaking & had to be replaced. The connecting pipes didn't lock properly & fluid was lost - this occurred 3 times before they were successfully fitted. Recently the gearbox has become sluggish to change up & requiring higher revs before going in to top. It also...

Thanks - a local expert advised removing R5 as well: the buzzing stopped; the engine will now start. As I have limited tools & the weather is foul I'm taking the car to said expert to fix. You advised a few weeks ago about a voltage drop problem which I then fixed; however it recurred...

Yesterday I moved my D2 about 100 yards then stopped & switched the engine off & removed the ignition key. There was a continuous loud buzzing coming from the direction of the gearbox which only stopped when the battery earth lead was removed. It recurred as soon as the bty lead was replaced...

Leads, not thread!

I can't upload a photo - is it the large white plug with the green & white thread?

Thanks -I had the top off the engine fuseboard today & lifted it. Is this the connecction to the interior board?\If so how is it separated?

Just recently my O2 TD5 has started making intermittent warning bongs. sometimes coinciding with the radio turning off. The battery at rest is ~ 12.3 volts. ~This drops to 12v when theignition is switched on & the fuel pump is charging. The voltage shown by a cigar lighter port plugin varies...

My 02 TD5 has been losing about 100ml/month until recently when it increased very substantially. Warning was given by a float switch I fitted in the header tank soon after I bought the car 21/2 years ago. During this recent cold weather the car does not warm up properly, even when set to full...

02 TD5 auto after overheating problem caused by oil loss from the cooler. It now does only 30 max up a moderate hill, whilst empty, so the 'box will have to be repaired or replaced. I'm told there are additives which will briefly extend its life. Suggestions & comments please.

my 02 TD5 developed front axle leaks both sides. So far only the rh seal has been replaced, but it still leaks. Should the tophat shaped collar that fits inside the axle oil-seal be fixed to the half-shaft? The one on my car is loose & can be easily removed. If it should be fixed, suggestions as...