Search results

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
  1. Y

    poor running

    Hi all my 2 1/4 diesel has started to cut out when going up hills, it starts again with a bit turning of the engine. Then play's up again on any incline. could this be as simple as the fuel filter? i did open the water drain plug on the bottom of the filter housing, there seamed to be a delay...
  2. Y

    brake servo

    Hi all this maybe a stupid question, but my series 3 failed it's MOT on a couple of things one being the brake servo not working, can i just remove it and do away with it, and will it then pass the MOT? cheers
  3. Y

    series 3 diesel starter motor

    Hi all does anyone have a starter motor for a series 3, 2 1/4 diesel, they could sell me? cheers
  4. Y

    welder needed

    Hi all is there anyone in or around the Edinburgh area that could do some welding on my landy (without charging the earth)? I think it need's some patches on the chassis and the passengers footwell, for MOT. cheers
  5. Y

    fairey o/d questions

    Hi all couple of questions re fitting o/d. firstly i have the o/d on the bench should i be able to rotate the protruding gear by hand? and secondly can i use the bolts that hold the transfer box cover on, to hold the o/d on? cheers stuart
  6. Y

    michelin tyres

    Hi Does anyone have any experience with Michelin XCL tyres? And would they say good or bad tyre? cheers
  7. Y

    wanted series 3 wheels

    Hi has anyone got a set of series 3 wheels, i just need the wheels to refurbish and fit new tyres to. cheers
  8. Y

    second row seats

    HI got a set of second row seats from a series 3 station wagon, and one rear bench seat with back cushion, but no base cushion, fair condition. any good to anyone? cheers
  9. Y

    wanted overdrive

    Hi does anyone have an overdrive sutable for a series 3, for sale? cheers
  10. Y

    what speed should i get

    HI all i did notice a while back someone posted a thread regards to the top speed of each gear (for a 1971 series 111 diesel station wagon) and the gears that should be used for for general road use ie. going up hills etc, could someone let me know as i didn't make a note of what was written...
  11. Y

    Fwh

    Hi i think i read in an old thread here that free wheeling hubs help the turning circle (series 111 lwb), is that correct. and could anyone tell me the turning circle i should be getting with and/or without FWH's. cheers
  12. Y

    series 111 gear stick

    Hi hope this is not a stupid question!!!!! what does the bolt/screw that screws into the side of the gearbox where the gear stick enters (seen from inside the cab) do? (it does look like it's for locating the gear stick) the one on my is as loose as, and falls out. cheers
  13. Y

    where to start

    Hi all Quick question, I was depressing the clutch pedal, while engine off. There was enough resistance to make me think the clutch was operating ok, it had been a bit clunky getting into first and second gear (series 111 LWB) when all of a sudden no resistance at all, I can’t see any fluid...
  14. Y

    back to landy's after a long break

    Hi all Just got back into landy's (series 3 station wagon) after a long break, and was wanting to know who is best to go to for insurance? cheers Stuart (edinburgh)
Back
Top