Search results

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
  1. R

    fuel sender screw pattern

    Hi Guys, I have a 6 screw fuel sender in the top of my lightweight fuel tank, its the standard series sender pattern. Does anyone know what screw pattern it is? Something like a SAE - 5 Hole pattern? Thanks Robert
  2. R

    Rear Output Shaft Removal

    Do you think a nylock would hold?? I must get toasty down their on the long runs?!?! Ill have alook to see what temp nylocks go to
  3. R

    Rear Output Shaft Removal

    Erm... yes... :'(
  4. R

    Rear Output Shaft Removal

    Yes.... the drive flange is off.... still doing the bendy snapperoo with yet another set of drifts
  5. R

    Rear Output Shaft Removal

    I've got the nut and the dish off and its still refusing to shift. I might take it down to the local garage and see if they can shift it! The most simple of jobs is never simple.....
  6. R

    Rear Output Shaft Removal

    yeah, it is, its snapped at both ends, eaten 2 drill bits and bent my drifts :(
  7. R

    Rear Output Shaft Removal

    I thought as much, I did have photos when i rebuilt it all but couldnt find them as they're VERY old..... thank you! :)
  8. R

    Rear Output Shaft Removal

    Hi, I Have a problem in that the rear output shaft on my transfere case has a snapped split pin in it. I have tried drilling and drifting it out but its a flippin mess and compleatley blocked..... Is there any way to remove this from the transfer case without removing it from the truck??? I'm...
  9. R

    Stuck Half Shaft

    Thats a good idea but from what ive looked at photos wise and seen if i did that i might end up just hitting the spider spindle?!?!
  10. R

    Stuck Half Shaft

    Yup the drivers side came out as one. I'll see if I can get my hands on a slide hammer to put on it. I'm guessing I'm going to have to drill and tap the shaft as the lightweight hs only have 1/4in hole in the end and its not massively deep.
  11. R

    Stuck Half Shaft

    Hi, I was driving my series 3 lightweight home last night and was at some traffic lights pulling away when i heard a pop and then lost power. I through the gear box into low range and got out of the way. then checked under the vehicle, all looked ok, so I put it into 4x4 and drove home...
  12. R

    front to rear brake line

    Hi, I have a 110 puma and i need to replace the front to rear brake lines as they've corroded and its failed MOT. I was going to buy some goodridge unions and hose to replace them, does anoyone have a rough idea what size unions I need? thanks Rob
  13. R

    Tyre size advice

    I know, seriously, ive seen glaciers turn more quickly..... ;)
  14. R

    Tyre size advice

    HI, I know this has been done to death but I just wanted something confirming. I'm currently running 235/85 on boosts. I need to replacce them as they're running low. Can I run 285/75 on boosts and how badly will it affect the turning circle? Does anyone have experiance of running these on...
  15. R

    Maf woes

    Hi, Thanks for that, I had the turbo hose at the front near side done about 2 years after buying it, they replaced that under warrenty. The elbow hose this time round was charged for and they were not of a mind to do it for free! :( I replaced the intercooler with a aluminium one from alive...
  16. R

    Maf woes

    Hi, I have a 2.2 puma. Engine warning light came on. Went in to limp and then after pulling over usual on off i managed to get to work where the rac vhap came and took a look told me it was p0101 and that i should keep an eye kn my maf wiring as it was cracked It was due a services in a...
  17. R

    wiper motor woes

    right chaps i did some more digging and the crank gear is dead/missing teeth at one part of it, a new crank gear has been ordered and I'll get it changed out this week coming.
  18. R

    wiper motor woes

    Hi Guys I had a wiper box start weeping rust down my bulk head and then it started to behave oddly, only wiping half way etc. So I bit the bullet and pulled the dash off, its a 2014 puma so nice and awkward. I've replaced both wheel boxes and the wire/cable that drives them. I've put the...
  19. R

    Binding Steering

    Hi chaps The horn had dropped off the front panel and got stuck between the steering relay and the front panel. Ive been through the rest of the system and cannot feel anything unusual. Yup your right i should have checked before pushing on, it was foolish! Thanks for your help all. Rob
  20. R

    Binding Steering

    I will do, I didnt get to it last night, It was after a bit of greenlaning so i wonder if something has moved around/ rattled loose. Thanks for the reply!
Back
Top