Search results

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
  1. C

    repaint help

    HI what you need is a fine pile 4" roller I use harris varnish rollers,you have got to give them a good wash in clean water first to remove any loose pile and let them dry for 24hrs. If you have a bare ally you must give it a coat of etch primer first then a coat of undercoat and two or three...
  2. C

    lights problem

    Thanks Zeaphod yeh that was my thinking I will give that a go and check all the other earthing points. cheers celtic.
  3. C

    Handbrake Adjustment (200Tdi)

    Let the hand brake right off take the split pin and pin out from the end of the handbrake cable where it joins the rod coming out of the hand brake back plate,ajust the the hand brake at the drum with the 1/2" adjuster till it locks the drum then back it off one click,now ajust the han d brake...
  4. C

    lights problem

    Hi all on my 1985 110 2.25 petrol when I turn on the side and head lights the fuel gauge goes to full and temp gauge also goes up any ideas?.:confused:
  5. C

    110 purchase

    Hi all what sort of price would you expect to pay for a 1984 110 pick up with a very good chassis and good bulkhead all panels are straight it has a 2.5 petrol engine and is currently sorn.
  6. C

    front prop phasing

    it's a disco 1 (1991 200tdi) as no master spline.
  7. C

    front prop phasing

    Hi all changed my front poip uj's,but when i took it off the prop came in two,the only mark on the prop is on the tube no mark on the other. can anyone tel me the correct uj allignment (phasing). cheers celtic.
  8. C

    Steering wheel wobble, Disco 1

    try the swivel pin pre-load,had the same with mine,ajusted pre-load and cured it.
  9. C

    vibration 91 disco

    yeh i was thinking along those lines,will take the disc into my tyre dealer and get the tyres checked and the wheels ballance again.
  10. C

    vibration 91 disco

    Hi all answer to some of the questions,it's manual,no i have not always had the vibration i will check the uj's for allignment.
  11. C

    vibration 91 disco

    Hi Treworgy no it's not lifted.
  12. C

    pitted swivel joints

    I used plastic padding metal,cleaned the ball's of with acetone first,filled the pits rubbed them with 1200 wet and dry'jobs a good un.
  13. C

    vibration 91 disco

    my 1991 disco has developed a vibration for 40mph to 45mph,replaced all the uj's,replaced front output shaft bearing,checked the rear one all ok,had the wheels ballanced,still got the vib's. any one got an idea what could be causing it. cheers celtic.
  14. C

    wandering steering

    Hi mate I had the same prob as you with a series 3 ,it was the ralco bushes on the swivels,changed them and all good.
  15. C

    clonking noise from auto

    Thanks Bobbler,the noise is there when the disco is stoped,and in N or P. cheers celtic
  16. C

    clonking noise from auto

    Hi All Got a 1998 300tdi auto,when you rev it and take your foot of get a noise like cogs trying to mesh,will do it now and again on tick over. does it 1st 2nd 3rd d n r p any ideas?.
  17. C

    New boots for a series 3

    disco 1 steel wheels fit to.
  18. C

    front half shaft bearing

    Cheers for the help,will get bits and have a go. cheers celtic
  19. C

    front half shaft bearing

    where do you get your bits from 90truckcab?.
  20. C

    front half shaft bearing

    Yeh going to do both,but will have to get sleave that axle case oil seal runs on
Back
Top