Search results

Looks like the transfer box is coming out then! It will be my maiden voyage into serious mechanical combat so I'm sure will be eye opening.... I take it I should be able to separate it from the gearbox in-situ and then remove? Or is the gearbox going to have to come out as well? Sorry for the...

Hi guys, as I don't have an oxy torch available I am thinking on using a drill and cold chisel to try and sepertate the components (prob a bit tight for the grinder), can you think of any better alternatives? Bear in mind this is under the landy and attached to the transfer box..... Also I am...

Started removing trans brake, that will be why the handbrake wasn't too effective, the entir drum is packed with oil and grease

Edit:

I have found this diagram in Haynes of what it should look like- I'll have a further poke around today and update with the latest horrors lol

Also just to add as a note of caution to those reading this, the above is only one of a number of problems I have uncovered so far on a vehicle which currently has an MOT, and looked perfectly passable on first inspection

Ah, sounds like fun on the horizon then.....I knew it was going downhill when I realised the state of the UJ I was replacing.... I take it this is the cause of the oil leak from the transmission brake housing? Echoing Land Raver, what would you guys do now, any idea of the parts which have been...

I knew it looked a bit suspicious! I have attached (I hope) I photog which hopefully compliments to poor description! That link looks very useful, that's my evening sorted....;)

I knew that was coming, at least it's a shock I'm prepared to deal with lol

Hi guys, I'm hoping you may be able to offer some insight into a few problems I ran into today when removing the rear prop from my series 3 88 to replace a UJ. Since I bought the vehicle there has Been an oil leak from where the yoke of the prop shaft blots onto the transmission brake, however...

I earthed the wired and when the ignition was turned there was a strange noise, sounded like the noise when the indicators are on, and the gauge remained unmoved. This seems to point towards the voltage regulator and some kind of a short/ earthing problem. If I order and fit a new voltage...

I have just had a look at the temp sender, notmquite sure whether it is a series one fitted (I'll try to attach a photog), although the plastic cover over the connection was half melted through.... Perhaps the cause of the fuses blowing???? Cheers, Hamish

The alternator is an interesting insight, hadn't even considered that as a possible issue. That said I assume the voltage regulator would be the thing to try first, does anyone have a part number/ link for this part? Or is it just a standard item? I'm not sure if it's connected however I have...

Hi guys, neither the fuel gauge nor the temp gauge on my series 3 88 (1978 I believe) work, however the speedo does; the fuel gauge reads empty even with about 3 in of fuel in the tank and the fuel warning light is on whilst it does this. I removed the fuel sender from the tank (it has 3 brass...

Flossie that's an ace idea re keeping everything replaceable, i shall Have a browse on tinternet for the single nad pipe. It will be good to restore the exhaust to its original position and make the rear actually usable. Cheers for all the help

Cheers guys that's shed some light onto the issue, if it was released in 91 is it possible that the engine change occurred whilst with the military from spares they had for 90's? After their sympathetic driving blew the 2.25 up....! With the stack pipe being a later modification (done v badly)...

Hi guys, I have bought an ex military series 3 88 truck cab (pickup) which I believe was built in 1978 and released from the military in 1991.... It has a 12j 2.5 na engine fitted which the previous owner believed was fitted by the military; the hand throttle works and there is a set of dual...

Hi just wanted to introduce myself; I have recently bought an ex military series 3 which I have the intention of working on during the time I am at uni during holidays etc (3 years), with the eventual intention of taking a gap year after uni to get stuck into some over landing/ off-roading. I'm...