Search results

You've seen them like the green one?

That's nice. What tyres are they?

Afternoon all, Since it's been a decade since I last wasted a not insubstantial pile of cash on a new (read: really old) Land Rover I thought it best to get myself a 1973 88" Series 3, sight unseen, on ebay. By and large I'm pretty pleased with it, the galvanised chassis is a definite bonus...

I owned this for a few years. I got it as a project, did a few bits and pieces over the years but the arrival of kids killed my free time and enthusiasm, so it sat for a few more years used primarily by my chickens as a house until it eventually went to someone else. I had an email from a guy...

Hi, I just sent you a PM, not sure if it gives you notifications of them arriving.

I'm looking for the hydraulic push fit union that connects the slave cylinder to the master cylinder, specifically the female part that is on the slave cylinder side. I know new slave cylinders come with that part fitted, so I didn't know if anyone had changed theirs recently whether you still...

Thanks for the replies :) Sierrafery, I was thinking the best place to fit the heater itself would be on the nearside bulkhead - ) don't have a FBH anyway, so space isn't a problem. It looks like getting the bend in a feed pipe off that metal pipe along the side of the engine could be a bit...

Evening all, Fed up with how long the TD5 takes to warm up, I went and bought myself a 2.2kw mains electric pre heater last week. Unfortunately it didn't come with any instructions, but I figured the best pipes to connect to would be the heater matrix pipes. A quick search on here and it...

HI Gav, Just tried sending you another private message but the forum said you'd exceeded your quota. Thanks for the reply. So is it just a case of bolting the FBH in the engine bay, connecting the existing wiring (is the wiring plug the same on the Rover 75/TD4 Webasto heater as on the...

Thanks for the replies. I think I'll maybe try a little silicon round the outside of the thread this evening. The position is already marked with a blob of paint, so I'm assuming it's a recon box (service history does show it was replaced a couple of years back). Regarding the little grub...

Afternoon all, After recently purchasing a '99 disco 2 td5 I noticed the PAS box was leaking from the side. The exploded diagram seems to have the 1" screw in panel/plug marked as a piston/rack adjuster and has a small hex screw at the bottom (part 13 on the diagram below). Does anyone know...