Hi,
I am doing a design course with the OU and had to come up with a concept, I can up with a Defender to keep forever. Please look at my poster and leave comments.
Thanks
has anybody wired their heater plugs through a relay and button?
I have a Disco 300Tdi in a 110 but my heater plug light has never worked, so I thought I might wire a standard relay with a push button instead of the timer relay.
Any advice?
Does anyone know about kickdown cable adjustments? I think my throttle cable went out of adjustment (or something else) but I messed with it and I have ended up losing my top end kickdown and boost.
All that happens now it my engine bogs down and becomes undriveable!!! I have disconnected the...
I have lost the tell tale light in my hazard switch and when I have looked I have only one of the push on side connections attached. Is this the wiring for the switch light?
Can you replace/check the bulb in a hazard switch?
My hazards work but the light in the switch doesn't light. Neither does the indicator warning when the hazards are on but the switch is the main tell tale, right?
Can someone with an early 110 post a photo of their lower seal?
My P channel looks too high and my rubber seal looks too low, in fact it comes out under the door!!
I could lift the rubber seal a bit but I lined the holes up and drilled them through the middle of the metal insert.
Please help.
has anyone else has this? I had indicators or stop light but when I had both together I blew the fuse.
It has a 10A fuse and think this is the right size.
The next time someone is under their truck could you snap me a photo or two and add some dimensions where I need to weld the brackets to my chassis. Or a photo of the axle links to show their position and I can set the chassis brackets to suit.
I know off roaders are best without anti roll but...
Can someone with 3 man bench seats in the rear show me a photo of you foward lower mounting?
Mine seems to come over the second row bracket but there is a difference in height???
Cheers.
Has anyone replaced their auto shifter cable?
I have found a write up but it says the shifter end star retainer and plastic retainer are tricky to remove and replace.
Any tips?
I am cutting the very rear part of my headlining (over door) to take a pair of speakers.
I should have cut the holes before I recovered the piece but I don't have that option now. What is best to cut the fibre board headlining material? Holesaw, jigsaw?
i am putting a MUD stuff dash in with a double din screen and a couple of power-points. I want to add a couple of guages to fill it out 'a bit', I have seen loads of cheap ones in fleabay but of these can anybody recommend a seller?
hi, I read somewhere that a 300Tdi Discovery 1 (auto) water temp sender will not read right when wired to a 110/Defender dash, is this correct? If so what sender do I need black ring or green?
Cheers
Before I put the head lining in I am considering bonding some plywood to the roof to allow me to screw a screen or screens to the roof.
Has anyone bought a screen from fleabay and can recommend one to buy or avoid?
Photo for reference.
i am not sure how original any of my wiring is because my 110 has been converted from TD to 200 and now 300Tdi.
Does anyone else have the same relays?
Behind dash there is the black dim dip unit and a gold metal relay, any ideas on the gold relay?
Then behind the fuses there are three relays...