Search results

UPDATE: Thanks a million guys, had a good inspection of the high/low selector and discovered it wasn’t going into high box properly, just needs a firm push into high and all sorted. Took the opportunity to change the overdrive and transfer oil anyway. Thanks for the help! Stuart

Thanks for the reply Rob. All of a sudden without doing anything it is working again. Seems to be a lot of play in the rear prop about 1/8th turn. Will post an update if anything changes...

Hi All, My MOT is booked for tomorrow evening, and low and behold I’ve lost drive to the rear wheels this morning. The prop shaft isn’t turning so I know it’s not the rear half shafts. Front wheel drive is working so I’m going to take a guess that it’s the RWD main shaft / or the flange. Can...

So my land rover started overheating a while ago, I replaced the radiator, thermostat, water pump and hoses.. Yet it still overheated. I can run it without the thermostat in and it does not over heat. I just had the head gasket changed there and hoped that would solve it but no. It is still...

So I've been driving the landy all of today with the thermostat out and it hasn't passed the Normal level, tried also bleeding the system at the heater hose and will try the stat in tomorrow and see how it goes

And come to come of it the fuel gauge read above empty and I ran out of fuel yesterday

Thermostats are opening fully, where would I find or test the voltage reg? It just seems to be showing hot, when I open the rad cap there is steam. The bottom hose also seems empty and cold with the thermostat fitted and is warm with trickels of water when stat out

So I have a 2,25 petrol series 3 and last week it started overheating. I replaced the thermostat but no change, had rad recored again no change, new temperature sender, new pipes but none of this has solved the overheating, when I take out the thermostat the engine runs to cold below the Normal...

UPDATE: Got a friend of mine who is a mechanic and once owned a series 3. He had a look at it and concluded (something along these lines*) that there must have been dirt stuck in the outward valve in the fuel lift pump. He disconnected a single pipe, blew into it, put the pipe back on and after...

I changed the fuel filter about a week before it ran out of fuel?

So until last week my Land Rover fired up and ran beautifully. However I then ran out of petrol, it is an old petrol tank and suspect rust / dirt being sucked into the fuel lines. Now the engine struggles to start and just keeps turning over. Sometimes after about 5 turns it starts up but will...

Indeed it's only 88" and it has a single brake pipe going into the cylinders

After fitting new brake shoes, spring and cylinders all round. My adjusters are not working. I have got the leading shoes etc the right way round but is there any possibility that I put the front shoes on the back or vise Versa and how can I tell? Thanks in advance

Hi folks, It's coming up to when I turn 17 and I've had a few quotes already (8k) which are extortionate! Wondering if any fellow Northern Irish citizens have been insured on a series 3 at 17 and what it cost you! Thanks in advance! Stu

£740 for 1980 series 3 in fair condition £100 for chassis shot blasting and wheels shotblasted and primed £70 on 2 new tyres £700 on parts £100 consumables, (wd40 etc) All told so far... Aprox £1700 A love affair money pit.

Does anyone know the proper name for it so I can find out more about it on the web. Thanks

So after removing my land rover front dash I found a green piece of paper tucked inside one of the vents... I think I've attached a picture correctly, so this paper has my vehicle specs, with what spec and extras were chosen. It also has the correct vehicle ID number that is shown on my...

Did you go for britpart parts?

Hi, I'm debating on buying a front Chassis Leg / Spring Hanger / Dumb Iron (whatever you want to call it) but all the reviews I have read on the web have said that britpart ones are crap and I cant seem to find any non-britpart replacements. So I am most likely going to weld it, however my...

On the original receipt it says blue and as far as I'm aware it has not ever been changed as I have full service history and receipts for everything down to bulb replacements and a respray or paint isn't here