Search results

When refitting the cam sprocket I noticed there is about 1/2 an inch adjustment on the bolts, I set them hard left so the timing chain lines up with the cam notch. However looking at where the bolts used to be on the sprocket the timing chain tdc marker would have been to the right of the cam...

Just putting the wiring loom back on my td5 after a head job.. The plug that goes onto the injector wiring harness is hanging on by one retainer clip (side plastic clip). So if this snaps I'm guessing the car will stop. Can you buy these plugs individually or do you need to buy a whole new...

Had a stripped thread on my fuel pressure regulator when installing new crush type gasket. Helicoiled the thread, is there a reason I can't reuse this gasket, yes I know its been crushed but I can't think of a reason it won't still work? Guess I'll find out a few miles on..

Going to use Loctite 518 to put the two halves of the head back together. Just wondering if the sealant goes on all flat surfaces (including head bolt hole surfaces) or just around the outside?

Just replaced water pump & thought seeings though the disco has done 240,000km's I'd change the head gasket, do a valve grind & be cool for awhile. The gasket on it is a 3 hole, were these fitted at the factory or has it likely been changed already? I have checked the service book obviously &...