Search results

Hi All Been a while since i've been here, due mainly to splitting up and giving wife the Rangie. But i've got back involved with it temporarily, Recently it showed soft fault when she was driving to work, then on the way home hit hard fault and she drove the last 3 miles or so fully deflated...

Hi All I'm selling my Nanocom Evo, for P38 Diesels, all in original packing, I bought it new from BBS around a year ago. plus a printed instruction set Any offers, they list at £405 on the BBS site and with shipping by paypal Other than that i will list on ebay.

Decided to go for it today, started at 9am finished at 2.30pm Overall not to bad of a job, did manage to break an ABS sensor, but lots on ebay so not to gutted Hubs were a bit stubborn to remove but big hammer soon shifted them.

Since I've had my P38 it has reported low brake fluid and the little red light is on I bridged the wires on the sensor but no change No faults reported in Nanocom ABS pump switch swapped, no change The low fluid is only reported when the ABS pump stops running, and I have noticed that the pump...

Well against all the advice on here I ordered a whole load of parts choosing the cheapest (Britpart etc) as I don't really intend to keep the P38 too long Full set of axle ball joints in Britpart boxes, joints are stamped Lemforder Axle oil seals are made by Corteco Track Rod end short one is...

Had fault light and no power a week or so back. fault wad needle lift sensor, cleared code then worked fine until today. Driving then no power and fault light, can't reset as it comes straight back. Rpm reading on lift sensor 0 So unplugged and measured resistance across pins and it's open...

I've read s many threads now on good old shock absorbers, I know the general conclusion is go with the factory unless you like it firmer I had a shudder when hitting bumps with LHF wheel, I rulled out shocks as the car is on it's 3rd set all dealer supplied and fitted, this set only 15000 miles...

Just rebuilt my injector pump as it was starting to look a little damp. Used a genuine Bosch seal kit, I'm familiar with this pump VP37 done quite a few in my time. I did mark the relation of body of pump to EDC to realign properly all other seals went on smoothly. Timed up with micrometer...

Quick question, on a manual it has 2 spring plungers that centre the gearlever Ashcroft no longer supply them, and they were fairly pricey so does anyone know the thread and dimensions

My aircon is intermittent, there is no real pattern as to when it will or will not work, just had a new condenser and recharged which was free as it did not work when Kwik Fit had it, Putting Nanocom on it I get error 33 Compressor Clutch Open (fault type=Current) With the car running and...

Fitted new air con condenser last night. when finished go to lock car, remote not working!! Other remote batteries flat As I just got new batteries and have been getting fob battery low message I swapped out batteries in both remotes, but whatever I try I cannot sync the remotes. Still...

Using my Nanocom I have set the one shot on all my windows to none, saved the settings but they still do the one touch down thing.Is this right? if so anyway else I can get rid of the one touch? Also I have found a setting the says EKA enabled and can be set to disabled, what does this actually...

Bits arrived today for service all gear oils etc, and drivers door lock, so swapped out lock nice and easy all working fine. Swapped over fuel filter, thought I'd then go for a run get everything nice and warm before draining overnight ready to refil tomorrow. Went for a drive, massive...

As I need to replace my drivers door lock, where might the cheapest source to get new ones be, not looking to get used. best I've found is £78+Vat Passenger lock must have s faulty microswithch as works fine when latch is in the door open position, move latch to door shut position and the door...

Well, despite my ever thinning wallet, decided to order a Nanocom Evo, as it seems to be highly regarded here. So have ordered the correct one for my DSE, but if anyone else is local to me (postcode RH16) then I'm more than happy for others to come and have a play. Also I would quite like...

I have already posted but maybe should follow protocol and say hello here I'm a first time P38 owner, first time to Land Rover, was lured to the dark side after my long serving Citroen XM came to the end of it's natural life, so not afraid of mechanics and electronics (thankfully). So it's a...

One for the lock guru's I have searched the forum for an answer, but found nothing quite like what Tallulah is suffering from. Also studied Rave but no answer. Pushing lock button on remote locks all doors and alarm sets, sometimes though passenger front will not lock. Pushing unlock on...

Hi All My first post, but have been lurking for a while, but never needed to post before. It's a 96 2.5DSE - Tallulah to her friends When started it shows the ABS lamp, and also the brake symbols with the exclamation mark comes on. After pulling away the ABS lamp goes off, which I believe is...