Search results

I refurbed mine recently, just happened to have a tin of blue enamel boat paint in garage, used cup wheel on outside, few costs of primer and this paint went on beautiful, colour match close enough for me

http://www.expeditionlandrover.info/200tdiconversion.htm#:~:text=Whilst%20we%20are%20at%20this,Series%20IIA/III%20friction%20plate. Sorry thought both parts had been used and working, this link should help

I would save your money and refuse the original , looks hardly used!

Good. Not be selling now 😀, At least you’re on the road again, but I bet the garage did not do anything you could not have done yourself! getting brakes working properly is a very common problem on here , lots have issues, but patience needed to look at everything methodically, In the recent...

Starters easy to remove, clean and test

I use their EP90 and that’s fine

I just back off the locknuts push the rod towards MC then move nuts so it’s nipped without free play then back off the nut nearest MC 1.6mm by eye move rod back away from MC then nip far nut up , hopefully make sense looking at diagram. You should bleed the brakes with adjusters backed off I’ve...

That’s a shame, sometimes you just need to have a cup of tea and cool down , that’s all part of the learning process, did you get the required clearance in the master cylinder pushrod and brake adjusters not binding can’t think what else would lock the brakes

😨 15 year old battery is going some!, when you checked the earth straps does that mean you removed them wire brushed terminals clean including where they mount on chassis / engine and you have done same with positive connections , battery connections clean and tight?

Absolute Agony, hope you feel better soon, have to try and find some positives out of this at the end of the day it can be replaced you can’t. There may be more salvageable parts other than just the front end. House insurance might cover other bits in car Mig, nanocom, Henry etc. Plan for how...

I got an AIRTEX 6395G a few years ago £58 , did you check the pulley wheels are tight , and no side play 6 mile should be ok

That’s good progress did you get some air out, have you got 2 wheel cylinders at each front wheel , there is a few other things to try if brakes still not adequate

Give the pulleys a wiggle and check the small screws are tight

The manual is here and tells you how to bleed properly, what set up do you have , have you. Got the twin leading 11” drums on front http://smithies.co.nz/land_rover/ Clamping all three flexis is the place to start to find where the problem is , and go from there as in the manual Did the shoes...

Aren’t the two heavier brown cables connected at alternator and on same terminal on solenoid.

Charging circuit similar to this

Looks like your charge light lead is ok, think it does need that exciter voltage to get charging Can you crimp in those big connectors a bit to get a tighter fit on the spade terminals also do this on the small one to make sure . You will have checked the belt tension by now, giving about 3/4”...

I’ve seen on here this choice of supplier and they export https://www.maer.com.pl/land-rover-series-88-galvanised-chassis

Stag88 last seen in 22, when you flushed rad did water come out as quick as going in, if so unlikely blocked have you checked the thermostat is opening in hot water