Search results

Make sure your axle breather isn't blocked as this will cause oil to pressurise and leak through the seals

Cheers, just wasn't sure how much jobs like this cost and wanted to make sure I wasn't having my pants pulled down having not used the garage before, least I know it's a fair price, Paul has offered to do it, but I am going to pay for him doing it as I understand it's a significant job and don't...

Pm sent paul

Tweaked the pump as sick of the slowness, massive improvement but need to fine tune as have slight black smoke full acceleration, engines sounding quite rough though, making a knocking noise, searched about on here and think it could be timing out ( need new belt fitting) or maybe push rods...

Cheers Paul, seen your thread, brilliant job you did, my drivers one is non existant , I've had to get the extended replacement panels, passanger side isn't too bad probably could be patched but on both the rot is high up towards the dash area so I think that would need to be removed before work...

Cheers for the link lynall, only just seen your reply, I did a search for a welder but nothing really came up, poor wording on my part most likely!! Will give them a ring and get a price, thanks

http://www.landyzone.co.uk/lz/showthread.php?t=146991

Gonna try a few garages today, my brothers a welder but lives in Scarborough and works pretty much every day so don't feel I can ask him to travel and do the job, I have pm'd nrgserv,waiting for a reply.

Ha I didn't word the title very good either but couldn't edit it, don't really have the time to do it myself now, spent several month staring at it and the panels gathering dust so just gonna bite the bullet and pay someone, or it won't get done and I will have to endure another winter of wet...

Cheers, I have purchased those panels already, just need them fitting but don't have the time to do it myself so looking for a reputable garage/person

I thought it was expensive as well, it was to spray paint but I aren't bothered about a perfect finish, rest of landy is rollered! The top bits look like the po has just siliconed new metal over the old which wasn't removed and continued to rot. See pic attached, Need it doing ASAP as...

Hi I have not really posted for a while due to a busy schedule, I am in desperate need of new footwells and the metal trims around vent flaps (door top hinge area) I have the replacement parts ready, but due to my work schedule don't have time to try and fit them, I've been quoted £450 to have...

How much are you after for it ?

Make it two boxes then !!!

Welcomr

No probs, would they not fit in a box? Can get cheap courier if they did;)

Yes pay at the gate pal, warrior is it gonna be open exclusively for lzers? And is it at the £15 rate ;):)

How much for the stub axels posted matey ?

http://www.landyzone.co.uk/lz/showthread.php?t=257322

It was the yellow challenge truck with the v8 fitted in the rear who was zooming around doing donuts