Search results

Was it hard fitting a new one in as a few of the ppl I know with experience are telling me calibration on sunroofs are not easy or are the just chatting breeze

Thank you for that going to check it out now

I must admit that did raise a slight smile but I just generally want a tidy engine bay and from my understanding silicone pipes are a better material thus better cooling than standards or am I wrong that is all my days of sitting at a cruise are long gone

Ok so I found the mega 150amp fuse had blown . I have replaced that the engine now cranks and starts for 2 secs and stops after trying to crank her again she won't start, I could here the fuel pump priming the first time but on the 2nd, 3rd I could not here it. If I leave her for 5 mins the fuel...

Not really what I'm looking for but thank you anyway

Where are the drain tubes located??

I have recently sealed my sunroof with waterproof mastik type stuff but she still leaks Can the water be running in from the liner/seal of where the roof bar fits

I have cleaned my headlights up a piece with some sanding power some lacquer and some wax to which I was very pleased with and wrapped the manifold

I know this may sound a little daft but can any one recommend any body that sells these or if they Evan exist. I'm in the most of sorting loads of problems on mine at the no but once done would love to clean the bay up with some nice tubes and hoses, I can only find them for the turbos ebaying...

I suffer with same problem but I still love her .....:)

Forgot to add it was raining and engine bay did get a bit wet but not drenched. The battery I have put on my hand held battery device me mate lent me and flags up good but it only has a reading of 12.2v The starter has a reading of 0.01 when key is in ignition being turned The cable trick of...

Yep all have been checked and they all ok :(

Hi guys, I have been using this website for a while but have only just signed up so a big hello to every one. Story starts with ....i had just replaced and rapped my manifold on my 2004 Freelander HSE 1.8 K Series with a second hand one as it had snapped from the pre cat But unfortunately I...

Hi guys, I have been using this website for a while but have only just signed up so a big hello to every one. Story starts with ....i had just replaced and rapped my manifold on my 2004 Freelander HSE 1.8 K Series with a second hand one as it had snapped from the pre cat But unfortunately I...

Hi guys, I have been using this website for a while but have only just signed up so a big hello to every one. Story starts with ....i had just replaced and rapped my manifold on my 2004 Freelander HSE 1.8 K Series with a second hand one as it had snapped from the pre cat But unfortunately I...