Search results

... and there is supposed to be an inertial sensor up behind the rear vision mirror attachment area.

How very confusing. I'll bet discolady regrets asking the question now:D Just my 2 bobs worth, but if the rear shaft doesnt turn when driving in difflock as she stated, wouldnt that mean the is a problem at both ends? 1. if there is a problem at the transmission end, wouldnt the turning rear...

Welcome Back Mate!:)

PMSL But it was the scorpion on the kitchen floor that bothered me the most!!!! Good job they aren't deadly out here eh?

Dont you hate it when you get unexpected visitors, and they turn up at dinner time?

Not sure if it's the same over there or not, but when Toyota Dealers fit bull bars, they have to remove the huge std tow hook from the chassis rail at the front. They then just chuck them in a box in the workshop and sell them for a couple of bucks to thems what asks. Original replacement...

They are GT Radials A/T by Savero which are an Asian brand I think. The local tyre bloke (Dodgey Tyre service, and I kid you not...thats their real name) have had quite a bit of trial and error trying to find one that will resist mulga stakes and gibber stones that are so prolific out here when...

I have a half second delay with mine from turning the key all the way and the starter motor kicking in. It has done this since I got it and has never changed. Should I be worried?

Must be horses for courses obviously..... I cant fault them for drive and ride in a lot of different situations, but out here, you sneeze and you get a flat tyre... had 4 flats in three weeks last year with these (not to mention $480 each replacement!!!). They are only 4 ply sidewall rated I...

It is quite confusing on my 2001 S2 as well. I have lights in the body (top is brake, middle is parking lights and then the reverse lights obviously, but there are lights in the bumper as well. The indicators are obvious but the red ones next to them are wired in with dual filament globes but...

Simple solution... a couple of Goldfish! :p:p:p:p:p:p:p

Mine is a 2001 V8 auto and the cd player (no stacker under the seat) has a LR logo on it and has 4 small little holes on the front, 2 either side. Is this how I get it out? 4 toothpicks? 4 loong nails? I need to get it out coz its squeaking and vibrating but stops doing so if I touch it. I was...

"..Can I breath out yet???"

Hi You guys... I have been away for a while...with good reason..did ya miss me???? The pic below tells the story of my absence, but during that absence I developed a small problem..with the car that is. ;);) My SRS red light has started coming on on the dash. It started coming on...

This might sound a bit stupid, but if it isnt completely engaging the latch, try closing it with one of the other doors open. Mine sometimes wont close properly because of the air pressure in the sealed cab. If I have a door open or a window down the pressured air has somewhere to go and the...

Central locking gremlin isnt a gremlin. The handbook says that if the vehicle sits for any length of time (overnight for instance) then you may have to unlock the vehicle with the key. The book doesnt say why this is so, I just assumed it was of Land Rover's idiosynchracies. I still set the...

Most ARB bars for Tojos and Nissans have a built in mountings on the bar to fit to the chassis rails for extra strength (why I always buy ARB Bars:D ). I have no idea about your model Disco but mine is an S2 with airbags and because of those, my ARB bar came with a **** load of mountings to take...

Waaaaaaaay too confusing. Start at the speakers and follow the wires to their ends and then connect them to where you know sounds is coming out.:)

good one S358....15 minutes of fame? Did you buy up all the papers at the local shop to send to rellies?:D

I have found on my rear door that the two bolts on the body make two equal dimples in the rubber door seal at the very top and let water in when I pressure wash my beasty. It's letting in dust there as well. Need to find a way to stop it. I might try removing the bolts and see what falls off eh?