Search results

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
  1. clivesP38

    Alternator works...sometimes !

    Put your voltmeter on your battery terminals, fully charged it should read about 12.5 volt to 12.75 volt. Start car and it should go to about 13.8 volts, put all lights and heater on and rev engine, it should go to 14.2 volts ish..
  2. clivesP38

    Which RR is the best model, which has the fewest faults?

    In the Range Rover category!
  3. clivesP38

    Which RR is the best model, which has the fewest faults?

    Do all Range Rovers have faults? Which is the most reliable model? Certain models have problems with air suspension, some gearboxes, some turbos etc. So which has the least problems?
  4. clivesP38

    What do my fault codes mean?

    Well I left the top of the EAS unit to see if it helped! It didn't so that not causing the problem. Went to maplins, they have a lead for usb to serial price at £20...... It' s still on there shelf. So where did you guys get your leads and did it work!? How much?
  5. clivesP38

    heater o ring replacement

    :eek::eek: :hysterically_laughi:hysterically_laughi
  6. clivesP38

    What do my fault codes mean?

    Just reading a post about drilling holes in the lid of the EAS box, will give this a try next. I chopped out the plugs and soldered them up last year. I will also try a new usb/serial adapter, got a maplins near me that should have one.
  7. clivesP38

    EAS over heat and cure

    Looks OEM!! Good job
  8. clivesP38

    What do my fault codes mean?

    Comm port numbers are matched and driver updated, so thinking USB adapter is cheap chinese crap and needs replacing?? Yes I know most things come from china, but some of you will understand what I mean!
  9. clivesP38

    What do my fault codes mean?

    Thank you to one and all. I know the battery is ok as I changed the alternator and battery together, so probably a bad connector but I did check the BCEM connections last year, just wondered if it may be something else. I will do a continuity check on the D wire in case there is a break in it. I...
  10. clivesP38

    CD volume low but Radio works fine!

    Another update, the CD player still has the same problem, it keeps going quiter on it's own. When this happen I use an air line to blow the inside of the CD player and it works agin for a while, I read this on another forum. Probably a hair inside getting attracted to the laser! When I get time...
  11. clivesP38

    What do my fault codes mean?

    Got the software and lead from Datatek last year. Seem to remember reading valves can't be open and closed at the same time, pressure switch?! can't quite remember but know someone here will have a good starting point for me!
  12. clivesP38

    What do my fault codes mean?

    Should have added that sometimes/most times I go out in her she goes to the correct hight selected but at some point WILL throw a paddy and all four lights on the suspension switch will flash, at the same time the message 'EAS fault' comes up on the dash and it goes to it highest setting. The...
  13. clivesP38

    What do my fault codes mean?

    OK, got around to looking at my RR, does anyone have an insight as to what these mean? Is it one fault causing several fault codes? 3 : F8:8_Hidden 4 : RL signal incorrect 5 : F8:32_Hidden 6 : RR signal incorrect 7 : F8:128_Hidden 0 : Engine speed fault 3 : Pressure signal...
  14. clivesP38

    p38 range rover air con condenser

    If a vacuum test in done then it should be obvious if there is a leak as the gauge will show a drop in pressure, even if it takes 25 mins, it will show. The only time to my knowledge it doesn't show is when the service port it is connected to leaks, but this only happens after the equipment is...
  15. clivesP38

    Strange wire???

    What ever it did power it most certainly not doing so now as the earth is not connected. Also it would only have been for something aftermarket like a phone system which prob got removed. It won't be powering any of the RR standard systems as it is clearly been fitted after purchase.
  16. clivesP38

    Ok. A few little problems...

    Problem 3: Rear Passenger Bulb Blown. Except it's not. But generally after about 3 flashes, this message shows up, the indicator clicks double time, and the brake light apparently goes with it. While the dash shows this message, along with the light for the trailer (I think) flashing too...
  17. clivesP38

    Sunroof will not set.

    Had a problem with mine shutting today, message said 'blockage', so I sprayed WD40 along the slide rails and all works fine now. Before it almost shut before opening itself again. Might be worth a try! Are you holding the button down when the sunroof is finally closed? until the message comes up...
  18. clivesP38

    Engine cutting out after approx 10 mins.

    I don't know enough about the RR BUT if it was a 'normal' car I would say to look at the coil. When they get hot sometimes a break is made inside and when it cools down the connection is re-established. As I said I don't know enough about the RR, it's probably something much more difficult to...
  19. clivesP38

    Car slows down and jerks at high or full throttle?

    Or on a race track, rolling road ........ ermm, can't think of anywhere else officer where I would have done that speed :eek: . I know the police don't like speeding in this country as when I got stopped for doing 93mph on a motorway I told him he must be mistaken as my cruise was set at 96mph...
  20. clivesP38

    Fitted clear front indicator lenses with bulbs.... they wont work...?

    OK, I meant your new clear indicators take orange bulbs which have offset pins, not clear ones as said above! Well I did warn you that most of the members were ****ed at the time of posting :beer2:
Back
Top