Search results

No need for soapy water, leak found on front air bag. Two new ones ordered! Now just got to find the 'how to' guide.

**UPDATE** All went well, but even though I depressurised as listed I still had a little pressure and a small amount of brake fluid spurt out which I washed down with water afterwards. Took less than ten minutes to complete. Brake light and TC light no longer come on when I brake and pump runs...

Thank you wammers, just what I needed to know. I, like many, don't post to often on here as lots of info can be found and you just get on with the job, so I will just like to take the time to say 'THANK YOU' to everyone who contributes any information to the site. Regards Clive

i have an iPad which will not let me download rave. I am about to change the brake accumulator and need to know if it is straight forward or not. I know I need to depressurise system by pressing brake pedal 30 times before I start and it is recommended to bleed system after which is fine as I...

Just a quick update.... My drivers seat stopped working, it's been two years since I fixed it! Turned out to be the spade connector on the thermo switch in the seat that I upgraded had come off!! A lot of work stripping down the seat just for that so take a bit of advice...if you have your seat...

Have had mine do the same once, turned it around on the driveway (facing uphill) and left it wondering what to do about it. Next time I started it everything was ok and the 35 mph message went! I still get, quite often, the EAS switch light all four lights (flashing) and get a EAS fault message...

Thanks Datatek, so will the messages go when the car is started up? Or do I need to clear them somehow? Will a faulty height sensor cause it to drop to the bump stop? Or is it more likely to be the compressor need rebuilding?

Ok, got these codes from my P38. 2 : FR signal incorrect 6 : RR signal incorrect 1 : Vehicle speed fault 7 : Vehicle has moved Also these were the readings from the boxes above F8 68 F9 130 Fa 0 Fb 0 Fc 0 The reason for looking at the faults was my RR has dropped to the bump stops (for the...

I would say air lock, take top hose off heater and run until no air comes out then put back on. Get some help to put a few revs on and to top up as you go.

Does it have a pipe from the rad back to the header tank? If so blow it through with an air line in case it is blocked and is stopping the air from bleeding back to the header tank.

My 4.6 gives around the 18.6 on a long run, sometimes it's up to 20.2 for a while but doesn't stay there! Around town returns 9.6, all these are based on the computer and I have only worked out a long run once and found it to be very accurate at 18.6 to the gallon. Having said that on the same...

My P38 sits on mud/snow tyres all year around also.

Try throwing a stone at it!! 5 years!

Charge the battery first for 24 hrs, test to see what charge it is holding, should be about 12.5 to 12.8. Start RR up and check voltage again should be around 13.8v then put light and heater on and rev engine, check voltage at battery it should be around 14.2v. If after starting the RR the...

Had a look at mine today, drivers side was a wire had come off! Someone had been in there before as they was no plastic square ring holding the glass in place, just glued in! The passengers side was showing power so I checked the heating element with a multimeter, it showed it wasn't making a...

Is it not just a stuck float on the sender unit?

I got one off ebay which said it was compatible! Came with the driver too!

If you have revved it after putting it under load, switching lights and heater on, and it drops to 12 v then the alternator high charge is not working and you need to replace alternator.

Got one from Datatek but it comes with a serial connector, I need to connect to my laptop which only has a USB port, hence I need a lead/adapter that goes from USB to serial.

Thought that's would stir the pot!! P38 has EAS issues, what about the latter models? L322 has gearbox problems? What about the latter? Etc etc What models suffer with what problems? Is one model better than another? Has less problems?