Search results

it took them years to put a decent back axel in a 109 perhaps they never thaught about havant ypu heard about the soldier riding moter bike with big magnet in pocket any there way there is evidence that putting petrol through magnet field alters the molicules of the petrol there is experiments...

perhaps they cant see the wood for the trees ha ha

I have 2 small strong magnets clamped opposite each other on fuel line just behind webber 4 barrel carb for the last 2 years I have not had to cut fuel down for mot is this just coinstance or does it realy help cant see any diferance in performance 4.6 v8

3psi should be enough to start it even if it runs out of puf at full revs have you tried blocking return pipe to make shore carbs are full of petrol are you sure you have a good spark at plugs are plugs wet if you cant get float needel valve out give it a good blast of air both ways what...

were the bits of metal steal or bronze coloured I had one of my transfer diff thrust washers break up

are the 2 gauze filters under under float needles valves free if you unscrew both damper coverslet them rest on top of carb rev up they should both lift the same time and the same hight

well done pleased you have got it right thanks for letting us know always interested in final results

good news about compression test hope pump not to bad thanks for keeping us posted

thanks for keeping us posted have you managed to get compresions tested I hav had to mans that broke a piston ring on one cylinder

yes could have been worse 2years ago bought brand new power steering box 1year imonth started leaking out of quad ring at end of cylinder got on to supplier they said 1 year that is it oninspecting quad under magnifying glass the outer edge had small cris cros markes all way round it I changed...

thanks for your replies seems like I am the lucky one 10 years ago got replacement gear box from a top reconditoner dident fit it for 10 years it has got prionunced whine in it whose going to belive me that I have just fitted should have fitted when I bought it to busey at time

hi has anybody had problems with trw clutch master cylinders I have had to that both started leaking about 3 weeks after fitting them on inspection the push rod ball end was shedding its crome? coating and the bits were being picked up by piston and ended up scoring bore of cylinder?

thanks for your reply

yes I think that would be agood idea rotary diesel injection pumps when worn slightly because it takes a bit more turning of to get injection pressure up this can retard timing slightly how does it start when realy hot we had an old hymac start perfectly when cold would not start when hot...

when lorry starts from cold on a cold morning does it fire up on all cylinders or does it mis and smoke white smoke and graduly fire on all cylinders when fully warmed up take off engine oil filler cap and see how much blow by it has some times low compression can cause this have yoy tried when...

has it got a thermostart going into inlet manifold idont expect it has don't know this model if it has some times they can leak diesel into inlet manifold if it has the bes way is to block fuel feed to thermostart and see if smoke improves ithink I spelt thermostart wrongly

had an impeller come loose on a scana bus once not very often this happens but good detective work on your part to find it

can you put it on axel stands and run it with all wheels of ground also as above take off one prop shaft at a time and see what happens was the front prop shaft set out of phase was proplem the same befor fitting new props? is steering box free play set correctly have you got the smaller tyres...

if y ou want to keep same calaperswith out fitting stanless steel pistons et the best way is to block 3 pistons get wife to push brake while you watch piston don't let it come out to far lub with brake fluid keep working it back words and forwords until it frees up

if you have acess to gas heat nut until white hot then quelch it with water until quite cold or split nut with air chisel if nut ison something solid split with chisel and hamer