Search results

Also what's a thorough engine? And there is no water in the drivers footwear so hopefully other the o ring.

That was prompt and very helpful!! Also much much cheaper. Garage quoted me £120 + plus vat per air bag!!

Yh i think w will be under the bonnet next to the fuel filter. If it's running loudly it may be running dry and then look to the one under the driver side rear seat. May be neither and then I have no idea!!

So the p38 drives very well and doesn't overheat. Good start. Needs 2 new front air bags... How much should I pay for them each? And if anyone has a link would be great! Needs a new abs accumulator. Again any suggestions and what price is acceptable? But today I noticed the coolant was...

How far is the mot station? If it's not leaking badly take it as it is?

Is it much work to replace the pipe? Might as well do it properly!! Especially if it's a pressurised pipe.

Disco

So one failure on my car was excessive corrosion withing 30cm of the three rear body mounts. It's the metal strip that runs across the back under the boot. Mines got a winch bumper on the back so didn't notice it. What's the procedure here? Cut it out and what do I need to replace it with? Do...

There's a screw at the top inbetween the primer and the filter. Unscrew it and the whole filter housing will slide upwards and come away. Then take the appropriate pipes off and replace the filter (it may be stiff to come out and if it is you can take the whole housing off and knock the filter...

He upholstera furniture as a rule but has done drivers seats in coaches before.

I've got a upholstery specialist very close by. I'm guessing he would be the person to do it?

And today was that day!! Have to wait until next year!!

Just a few things that needs doing... The roof sags... What's the best way to sort it? Ive seen some that claim to have new roof linings? The abs/brake vacuum kicks in either every time or every other time the brake pedal is depressed. I read it should be every 4 times so what needs replacing...

If it worked last summer and it's out of gas now then I'd say there will be a leak somewhere and you'll be in the same position next summer getting it topped up again!! If you get the leak sorted it should just be a one off cost!!

How did you get it out? And what's the new problem?

One way to to make your own tool is to find a shaft that fits the slave bearing perfectly. The wrap insulation tape around the shaft until it fits perfectly in the clutch plate. I've done it on a merc sprinter and a coach and its been spot on.

My dad's new p38 has locking issues... The guy said that he had it looked at and the garage "replaced the back of the fob" (he had no idea about anything tbh.) he said it worked fine for a few months then stopped again. He didn't look I to it anymore after that. The fob has abuse marks on the...

Td4

OK cheers. It's a tdi 5 so decent engine. I bought it for 1000 and the body has no marks or scuffs anywhere!! Think I might keep it! Think I might leave the prop off as my wife won't be going off road!! Just taxiing kids about!!

I don't really want to sell this car as it's too good to sell! But it's off the road awaiting my wife to pass her test and it will cost her a lot to insure. It's done 140k miles but is a superb example. Few issues with it. Not all the doors lock and unlock on the fob. Guessing it the mechanism...