Search results

Many Thanks Sierra, thats great , I will try harder and concentrate lol ! Will look at this tomorrow.

Ok , that’s great , I think I get your help with that , I will try this on Friday pm , as I’m off then . Thank you so much for replying , much appreciated . Looking at the wiring diagram and when you say to measure at C0647 , would it be better measuring at C0771 as that would be the end feed at...

So now I have the Active Roll EcU and scrolling down the various components and values therein . I get this —with engine running and fault light on . Any interpretation would be helpful , but it still looks like a wiring fault , there is good voltage to ecu module .

L320 . 08 plate. Reading the manual for GAP it does say on page 106 that it’s all possible to read live values . I’ve just updated the tool so will see if it’s enabled the ecu list . Measured the resistance on the Pressure control valve ant comes 5ohms and I measured my spare one snit 4.9 . I...

I see what you mean , that’s good . Just didn’t see what you meant there !

Ok , many thanks I have a spare pressure control valve so will measure that first. I have in fact measured a voltage off the plug off two pins but I'll check that tomorrow. I was originally going to change that and so a guy who is very knowledgeable and runs a L/R garage said that its rare for...

My aid ? Ha all I have is problems !

Yeah had a good look through, the only thing I get is ecu info. I will check the Gap site .

Thanks for letting me know about this , any help on RR forum appreciated as well as it is basically the same system .

The choice I want of this group of ecu’s doesn’t seem to be there.

So , I linked to a thread on the wrong forum , so on here with a code on RR Sport dynamic roll. Code is C1B11-1D(AF) this off a GAP IID Tool. Im told in the last forum that this is nothing to do with the pressure transducer . This is the path I am following at the moment. . I need to go into...

Ok , sorryl this is Rr Sport , the diagnostic is fairly clever , its GAPP IID TOOL. Perhaps I can get some live data on the ecu , never thought of that ! So just link which terminals , I have read its the parallel ones will have a look and get back . Thanks in the mentime!

Ha just a bit late in reading this today , , bought a thin walled deep 27mm socket and its too long! Will have a look . Do you remember the code you got and followed up . The one I got is C1B11-1D{AF}.General Electrical failure-circuit curret out of range . I can get 5v with ign on but nothing...

A good read including the invaluable write up on the Disco pressure transducer replacement . Not sure if I have the space for a 27mm socket though , I have a RR Sport with same block , maybe have to slacken the valve mounting bolts to chassis.

Ok I get that , but I need to know that there isn't a stying of other faults lying in there to prevent the process of bleeding. Can I assume that because I have pressure sensor fault c1A09-16 that comes up can be of two things either its locked out because of air introduced by changing the...

Has anyone bled the hydraulic system on Dynamic response other than getting a dealer. This is on an L320 RrSport, I have just fitted new set of front hyd pipes. Refilled reservoir with 75 % of 1L .It not going anywhere. I know the valves have to be opened and then bleed electronically by...

Yes , affiliated there , but need help , with a expert I think. Thanks.

Old code appears after inlet manifold replacement. CAR RUNS FINE.So I don't know .

A bridge too far at the moment, the engine pulls a lot smoother than it did, definitely a cracked manifold at this stage , will see if it settles down . Thanks for your help and knowledge.