Search results

Iv tried all bloody ways of finding this part but cannot find it on google , mainly because i dont know what there called. on the D1 front inner arch there is a bracket where the brake hose goes through, then there is like a clip that slots round the pipe to stop it dropping out.. Can any...

another +1 for the 3 tonne clarke one, iv had mine over 3 years now gts abused regular and is still going strong.

Hmmm mine must have been labelled wrong as my groves go the opposite way...need to turn them round lol

not just any tom dick and harry can do it theyve done oads of research into how much fluid to re use and other shizzle.. new one wouldnt like to think how much, not sure even if you can still get them

well getting round to sorting oter bits now, so my disco has a 4" lift so going down the route of front arms and panhard rod, now im pretty set on QT front arms 6 degree, but panhard rods im not sure would a cheapy one do Rover Range Rover classic Adjustable Panhard Rod DA1110 | eBay or...

bell engineering refurb them, 250 for vcu and bearings supplied with yours being sent back, and an easy job to do

Fair enough that will do...yeah I know most bits needed...disco or defender vented disks (same) defender 110 caliper and pads...and away I go lol

im assuming you dont need caliper carriers for the 110 calipers, and the disco ones will do? im off to order my bits tomorrow thats all

well went to frikley over past few days and had a minor issue i lost all drive, no idea why pulling peopl eout helping out etc, pulled up stopped had a brew went to set off and nothing... turns out it was my front dive had blown... but even in diff lock i wouldnt drive, yet when i put the...

As on the description 1.8

I think from memory that it's smaller about 6mm bit not 100% as I now have custom tank in

According to RAVE there are 2 relays so need to work out how they are used but thanks for the cabling. ..iv managed to wire them.through a fused switch at min will try get them on a relay tomorrow..need to.wprk out stalk wiring too

good start, im sure there will be many more mods for you..welding doesn't look bad either to say you've never done it before ;)

Can anybody help with wiper motor wiring using the existing twisty switch? I'm rewiring disco and wipers are last thing on my list...honest Iv found what feds the motor for the 1st speed and fast speed but need to know how to wire it so I get park and intermittent back if any body can...

evening chaps had abit of an odd one this monring, drove about 25 miles stopped car all good, went into shop came out no more than 10 mins, came out started car but rev guage no registering put foot on accelerator nothing..turned he off, then back on, all fine and hunky dorey now iv...

whats lowest you would take collected?

what cabling is inluded with the fan? does it have a thermostat with it to auto kick in

cool thanks jam, may have a look into this aswell then now...more money lol

or something like this https://www.merlinmotorsport.co.uk/p/telemetrix-speedo-100mm-0-140-mph-cb-100t-sp-14

now then boys and girls.. as some of you are awre im currently re wiring my disco and creating a new centre console.. Iv had a thought about my speedo dials, could i get an after market speedo and reqwire it to the existing transducer thing on the gear/transfer box? basically my dials are...