Officerdibble
Active Member
- Posts
- 92
- Location
- Northwich
Fuel filler cap support bracket
- Thread starter Officerdibble
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
Drill the pop rivets and it comes out no bother. Or it should as mine did. I have some old road signs lying about and as their aluminum I made the new part out of that.
Anaconda
Well-Known Member
- Posts
- 4,619
- Location
- Thames Valley
Pretty sure I saw one. YRM maybe
Anaconda
Well-Known Member
- Posts
- 4,619
- Location
- Thames Valley
miktdish
Guns n Chainsaws
- Posts
- 4,746
Forrest Gump
Well-Known Member
- Posts
- 459
- Location
- Edinburgh
Changed that with the Yrm one. It was easy enough. Good quality part too. Meegos idea also works. Did the same with a bit of sheet Ali the size of the recess and with an angle at the end to rivet onto tub as well. Yrm one is actually easier to do with the tub off but that turns into a bawbuster. 
Officerdibble
Active Member
- Posts
- 92
- Location
- Northwich
Mine looks like it’s been spot welded so might be a bit trickier to remove
Anaconda
Well-Known Member
- Posts
- 4,619
- Location
- Thames Valley
Do you not drill out the spot welds and rivet the new one in place using the same holes?
Or cut it off from the back and bond it in place, would look neater.
Officerdibble
Active Member
- Posts
- 92
- Location
- Northwich
Nice one …. Ordered
Officerdibble
Active Member
- Posts
- 92
- Location
- Northwich
The spot weld are a lot bigger than rivot holes so I haven’t figured out which it’s the best way to do it , probably wait until the part I’ve ordered arrives & contemplate a plan
0utcast
Member
- Posts
- 33
- Location
- West Midlands
Let us know how it goes, mine is looking a bit ropey and I'd be interested in how it goes for you.
Are you sure? I have done other panels with YRM replacements where you drill out the spotwelds with a 5mm bit, and then split the panel with a sharp chisel (I use an old wood chisel as thinner and sharper than a metal working chisel and ali is soft). as long as you centre the hole on the spot weld , which is the difficult bit, I have never had an issue with oversized rivet holes.
