Recent content by zinnemann

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
  1. zinnemann

    Disco 1 Disco 200TDi Aftermarket Diesel Sender Unit Wiring

    No, the disco does not have a diesel burning heater. The sender unit is the aftermarket type like this one: http://www.paddockspares.com/prc7129-fuel-pump-and-sender-unit-diesel.html
  2. zinnemann

    Disco 1 Disco 200TDi Aftermarket Diesel Sender Unit Wiring

    Yes, completely certain. Could it be an earth?
  3. zinnemann

    Disco 1 Disco 200TDi Aftermarket Diesel Sender Unit Wiring

    Hi Sierra. Thanks for your answer. Yes the fuel gauge works. Do you know what the small wire is for?
  4. zinnemann

    Disco 1 Starting and Stalling Problem

    Yes the bearmach lift pump requires a spacer. It was included in the kit.
  5. zinnemann

    Disco 1 Starting and Stalling Problem

    Glad you asked :)
  6. zinnemann

    Disco 1 Starting and Stalling Problem

    There is almost no fuel in the fuel filter. If you ask a fourth time I suspect there will still be almost no fuel in the fuel filter.
  7. zinnemann

    Disco 1 Starting and Stalling Problem

    The pump is from Bearmach and the pipes are on the correct way around.
  8. zinnemann

    Disco 1 Starting and Stalling Problem

    There was almost no fuel in the fuel filter when I checked it.
  9. zinnemann

    Disco 1 Starting and Stalling Problem

    Yes, I put on a new fuel filter a few weeks (and zero miles) before I replaced the lift pump but I have not put on a new filter since I replaced the lift pump.
  10. zinnemann

    Disco 1 Starting and Stalling Problem

    Sorry about that Magic. There was almost no fuel in the fuel filter when I checked it. My current prime suspect is the wiring at the top of the sender unit. A loose wire can't be good and I guess it might mean that the sender pump is not operating. Do you think this could be the culprit...
  11. zinnemann

    Disco 1 Disco 200TDi Aftermarket Diesel Sender Unit Wiring

    Hi all, I am investigating a low power problem on my Disco 200tdi and by elimination I suspect it might be something to do my unloved sender unit. I removed the cover on the boot floor to find that the small wire seems to have snapped off from the plastic plug that slips onto the metal lug (see...
  12. zinnemann

    Disco 1 Starting and Stalling Problem

    Many thanks Magic and Paul. I have done the following: Cleaned out sedimenter Replaced diesel lift pump Cleaning out the sedimenter made the exhaust gasses much less black but neither of these has given my disco any more power. It still does not want to go past 1,500 revs. I have removed the...
  13. zinnemann

    Disco 1 Starting and Stalling Problem

    Thanks Magic. I will check the level in the fuel filter tomorrow. Regarding the sedimenter should I replace the O rings on it when reassembling it?
  14. zinnemann

    Disco 1 Starting and Stalling Problem

    Thank you Paul. That is very helpful. I want to check everything possible because at the very least I will learn a bit more :) I was not aware of either of those potential causes so will investigate them with vigour. I am also open to any suggestions from other members.
  15. zinnemann

    Disco 1 Starting and Stalling Problem

    Hi all, I have a problem that is vexing me. My manual Disco 200tdi (92k miles) will only start on the second turn of the key and when I get to junctions it wants to stall. I can prevent this by quickly applying some gas in neutral. I have cleaned the air filter and replaced the following but...
Back
Top