Recent content by Zillah

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
  1. Z

    Disco 2 air suspension

    Hi sierrafery I swapped sensors and all seems to work at least until I went to put a cable tie around the sensor plug for a bit of added security . Air bags emptied and warning light on . So I’ve ordered new connectors with the tails on hoping that’ll be the end of this .thanks so much for your...
  2. Z

    Disco 2 air suspension

    Thanks sierrafery photos and wiring diagrams made that job easy . All connections tested good for continuity right up to the slabs .Maybe worth a new connector that fits onto the height sensor as that's the only connection I can't properly test . Any other ideas ? Am I right in thinking that a...
  3. Z

    Disco 2 air suspension

    hi everyone my first post on here so here goes Amber light constantly on for suspension nanocom says no fault found but when I went in to slabs outputs the right sensor value reads 0 left was on 70 voltages where 4.8 and 5.1 which I'm sure is ok .new sensor fitted to the right this week also...
  4. Z

    New member

    hi everyone thanks for allowing me to join your forum I've scrolled through the different sections in the past with great interest . The knowledge I've picked up must of saved me a fortune ! There's certainly a lot of you on here that know your stuff . I like to think I'm fairly handy with the...
Back
Top