Recent content by willFD94

While restoring a 1975 S3 Diesel the banjo bolt on the lift pump sheared, I've looked up the part number and it is 90568489. This part has been discontinued by Britpart unfortunately and i have only found one seller. Does anyone know of superseded part number for it, or an alternative that fits...

Hi, I’ve just brought another landrover a LWB pickup this time, it is not running currently so I have to transport it to get it home. The transporter hire I got a quote off said their vehicle has a limit of 1.25T, the web says the series 3 LWB weighs 1.5T. But is this for the van or pickup...

Installed a Weber carb on the car yesterday and engine now running very smooth, going to take the zenith carb apart and service fully.

Started the car again the other day no problem after running for another 10 mins or so it died and then would not start again. When running it was extremely rough and very black sooty exhaust gases. While it ran I used spark plugs lights to check all the spark plugs getting power which they...

Thanks guys put it in the correct place and put age and petrol etc. Cheers Will

My 1977 Series 3 2.25 Petrol which I recently rewired (everything except the alternator wire as I did not have a new connector to the alternator) Ran after the rewire for 40 mins, I then turned it off it started fine three more times. On the third time the engine started dying then stopped and...

Hi Everyone, Im Will, I brought a 1977 Series 3 Just under 2 years ago, in quiet a state. I’ve done it all up over time. I’ve had it running and doing runs to Suffolk and back. Recently it stopped running for unknown reasons I suspect now it was a dodgy ground. I have rewired the whole thing...