Recent content by v8 shaun
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
-
V
Be aware that the second set of bolts underneath hold in a massive spring that will take your head off!!!! read manual first!!!!!
-
V
Hi , if its the same set up as 200 then in the top of gearbox where gear lever gos in there is a plunger that works reverse lights.this sticks on 200s leaving reverse lights on and making gear selection difficult.
-
V
Hi, if you fancy a trip to herne bay i can sort you out a gearbox
-
V
i reckon standard shocks give a good ride,2" longer shocks which most fit make for harder ride and the springs will only drop so far anyway.
-
V
lots of wd40 over night make sure no leaks and bleed well after.pump brakes before you drive.They will have to be clipped as before to pass mot.best of luck.
-
V
The timimg chain and gears themselves also can wear causing the timing to change producing smoke.
-
V
My trucks been in bits for a while but from what i can remember the heater switch is only off and on,the lights are three stages so no good. I assume you have checked fuse is ok so you will have power to light switch.With small bit of cable you can bypass switch to test lights.
-
V
Send us address and i 'll get bits posted to you this week,cheers shaun
-
V
Is there a spark from coil? if so check spark plugs for sparks,if all is well with these then its a fuel problem.The coil could have had its day,they can overheat a few times giving you short journeys before totally dying.
-
V
Hi, when you say it won't start does it turn over but not fire?
-
V
Hi, I have the bits you require if still needed. V8 shaun ,Cost post only
-
-
V
Hi, sorry for delay in reply, the s111 has a 3.5 efi or will have when it's finished.The disco is 200tdi and is set up for off road although is now also used everyday as sold our v8 disco to help fund s111 rebuild.
-
V
Just had a quick look at my bulkhead and i reckon it's a dash out job.Its to the left hand side of dash binacle so tight access for spanners!
-
V
Hi everyone, I live in herne bay kent.At present i have a 200tdi disco and a series three that is being built from chassis up.I have worked on many early landrovers up to td5 so have some useful info to share.Anyone close to herne bay with problems i would gladly help with repairs or...