Recent content by tomtomtom

Cracking job mate! Where in the midlands are you?

Egdon 4x4 are pretty good just south of Worcester. Or MM 4x4 in Worcester itself. If it's just remedial work, I've found Broadway Garage in Broadway (Glos/words border) to be very good. Also Neil at landtec services in Evesham.

Bump.

Hi all, Just to make you aware that I will be starting up my Evesham Land Rover pub meet again this week. This happens annually from April to September time and is always on the last Wednesday of the month. It would be great is some of you could make it along - it's always difficult getting...

Hi all, Does anyone happen to have either a military roll bar/seatbelt bar that can be fitted to a defender to allow it to have a soft top? I know they can be bought new, but wondered if anyone on here had one first! Cheers Tom

Messaging for Jack. Cheers for the reply, very interested. Look forward to measurements!

There are no bolt heads, that is simply a stud welded to the bottom frame of the door top. Best option would either be to cut off and replace, or recut the thread with a die and grease it well!

Got any pictures pal?

Might be something to consider, but my local scrap metal recycling plant has many of them stacked up near to the weigh bridge, I guess these get pulled out of scrap piles and reused. Perhaps you could have a look at a local metal recycling place near you? Maybe they do the same?

Raining in the midlands!

OK, anyone else got one available?

Hi all, On the lookout for an A bar for a defender if anyone has one lying about. Me tail rather than the plastic one. Brackets for spotlights would be great. Oh, the closer to Evesham, Worcestershire the better. Cheers folks.

Hood sticks from all wheel trim are very good. Fit well. I've had mine 5 years now, no issues at all as yet!

Birmingham badges were used on series 1s and Also the very early series 2s (up until February 1960)