Recent content by SullyUk

Cleaned out the filter and ran through the bleeding via nanocom and behold I have good activity in the tank again!!! so as you mentioned seems like it was possibly hydro locked. I always appreciate the time you take to help. Thank you again. 👍

Just wanted to check that after I have done that, do I start the engine or do I get the reading with the ignition just switched on?

Thats great thank you. I will do that tomorrow.

Ah ok, that would explain it then. Now as electrics are not my strong point may I ask if you have a pic of how to bridge the contacts cavities please?

I hooked up the nanocom and went into the ACE section for outputs but am struggling to see the run test check option for the PCV and DCV any help would be appreciated so I can see if they are clicking or not.

Will give that a go in the morning and let you know. Thanks again.

I partially undid the banjo with the engine running and it sprayed out like an arterial bleed so there was plenty of pressure and the tank dropped from max to below min so I shut off the engine immediately. So does that mean the pump is good? There still isn't any activity in the tank though. So...

Thank's sierrafery. 👍

Thanks for the swift reply its always appreciated sierrafery. Will try that and see what happens. If the pumps gone, there doesn't seem to be any available from any of the regular retailers here in the UK and there are only 4 on eBay and they all look well used sadly.

Hi all, well after several months of trouble free Disco2 driving I have had the amber ACE light come on (it did flash red once but that went off when I stopped and restarted the truck. (Typical that have my MOT next month!!) It always goes out when I stop and restart the car but them comes on...

I connected up my nano com this morning and managed to disable the horn when pressing the open button so then tried to level my suspension but alas it dropped completely. I did see on the nanocom that transport mode was enabled so I disabled that and pressed the write to eco button, but I am now...

That’s great thankyou. I

I connected up my nano com this morning and tried to level my suspension (it was lower on the left) but alas it dropped and I have been unable to get it to raise. The nanocom says test complete each time I press the raise button and I can hear a clicking from the compressor but it doesn’t...

Ah ok, with electrics not being my thing can I ask how you connected it up to a battery to check if it was knackered?

Hi mate did you find what the issue was at all? I'm having exactly the same problem and I have blown 2 FL9 fuses in trying to source the issue.