Stone56's latest activity

Morning All. :D Still here (it seems). :) I was making some axles for a friend out of 15mm Silver Steel round bar yesterday. The end needed drilling and tapping at M8. Gosh that silver steel is tough. Very hard to cut the thread. Got to work...

Mornin Drizzle early on but brightening up Not be needing factor 50 in Scotland by the looks of it 🤔 Got me tools in the boot and a brolly, goin round to GF's to pick up her bags then see if there's any room left for mine 🤣 Should be heading...

Traps still set.

Trap not tripped yet.

I didn’t ask, but probably. 🤪

Was yours called kev anorl?

I had a big rat in a shed at work today and it was that busy it didn’t see me which was a mistake. Nipped out of the shed and fetched a 20 gauge, then went back into the shed and said bye to mr rat🫢

Sossij has bin put on one trap. Bit on trap and bit each side to tempt it frew either door hole. This time eye has also set the trap. Somefink eye fort eye'd done before but they may have triggered or eye fergot. Dun't fink so. First trap were...

Sossij is cooked. Eye has eaten the rest.

Me nayber ses e's er rat.

Dust pan and brush to clean it up then and wash the walls down He can smell you need to rub the trap with composed

Dust pan and brush to clean it up then and wash the walls down 😯

Got her rats mixed up with her hedgehog 😗

That’s a good bodge last ages can’t see it taking any weight if it’s just a sensor. I had mine out a week ago on 10 mile bumpy off road, noticed the vacuum and washer bottle shaken off its corroded mounts on inner wing, so I cut up last of left...

Yer I think she will be fine thanks, shes got a few weeks of tabs which make you sickly. So she might get a tad moany. Oh wait a min has she been taking they tabs for years. 🤣🤣

He's a gerbil not a rat.

Kev me rat

Pop strings https://support.microsoft.com/en-gb/office/pop-imap-and-smtp-settings-for-outlook-com-d088b986-291d-42b8-9564-9c414e2aa040

For that amount I totally agree. Mixer is going again. J

The cable does not appear to be pulling correctly ? It's much easier to do with the assembly on the bench or table. These screws should adjust the latch towards the front lid. There's a hole to access the screw heads for adjustment. If...

From where the local hairdressers in case they get a power cut. :p

Hope the tests come back ok 😯 have had 7 so far this year mainly dropping from the trees one was buried deep could not pull it out resorted to cutting it out with a Stanley blade 😠

Yes we have Lymes disease here, misses wasnt well yesterday didnt tell me until I came home from work...pounding headache sharp neck pain high blood pressure/temp with blurred vision feeling sick n dizzy (well more dizzy that usual 🤣) Called...

🥺

😱

Thanks it'll be good hopefully Three countries in 10 days 🙂

If I lived near you I'd be over to your place with lappy and beers! 😉😉

Do have a great time wherever you are going!!😉😉😉