Recent content by Staggo

Many thanks for coming back on this have got two different size wires checked with magnifying glass to see if I could see tracer line shorted the smaller wire to earth blew fuse No2 (20amp) in interior fuse board bit unsure about trying other one as its bigger

Hi Everyone, Can anyone clarify what colour the cables should be that feed the switch which operates the interior lights and alarm on the rear door please? I have looked into this and it says that they should be purple with a blue line, but I can only find 2 purple cables, can anyone shed any...

Hello All, Yesterday when I took the head of my 1989 2.5TD 90, I noticed the swirl pots were cracked. I obtained some new ones, along with the pins to secure them in. I managed to remove the old pots but the pins are stuck solid and I can't grab hold of them with needle nosed pliers. Anybody...

Thanks James Found it. Looks like an older block with number 19J19597C Staggo

Good morning everybody Trying to find block serial number on my 19J engine to see if its a later block looked in obvious spot next to water pump but not there! Block is a reddish colour could it be new short motor? block is stamped with issue A hope somebody can shed some light? :confused...

Used Hylormar Aerograde Sealant. I made sure the sump was spotlessly clean. I then looked a friends C plate Land Rover and on the sump there are reinforcing plates on the outside edge of the sump. By the way mine is 2.5 TD and it is on a F plate. Should there be reinforcing plates on my Land...

Have tried to stop sump leaking 3 times using sealant, can you fix a gasket to this sump and should there be reinforcing plates on the outside where the sump bolts on?