Recent content by silentbobt

I had a similar problem it was a failed slave cylinder ive just replaced mine over a total of 8 days dodging work and weather. job was done on axle stands and wasn't much fun

[/URL][/IMG] So reversing out of my driveway and clutch pedal fell to the floor. The cause the bleed nipple has come away from the slave cylinder. Question can this be refitted without removing the gearbox Not holding much hope for a positive answer. Clutch was changed about 5000 miles ago max...

I figured it out

Seen this whilst researching removing my own

Ive recently swapped the nsr door mech with a rover 75 one they are identical

Me lol and now I'm banned too

I use it to lift her high enough to use axle stands or blocks

I use 1 of these Hi-Lift Lift-Mate (LM-100) - lift vehicle wheel directly from the wheel | Hi Lift Jack Company

Great write up

I was going to say I'm in NI but I see that isn't an issue yeah I'd sell them 4 17" alloys with legal tyres but ive a good local contact for cheap good quality rubber. £100

I was very lucky to see it posted on Gumtree by a RAF guy being posted from the base 4 miles from my house at Aldergrove N.Ireland. A really lucky find over here

AFIK rover 75 door mechs are the same as the hippo ones

Tyres are bfg 225 /70/16 no need for spacers but I am planning on fitting 32mm spacers in the near future

22mm stop end EGR plug

Fitted new wheels and tyres Before After