Recent content by seriesthinkin

Just sorting out my suspension on me 88" S3 rebuild. I've been reading up about Parabolic springs, not completely sure if they're what I want (But thats another issue). Anyway I am not sure of the following. Shackles, Do I fit longer ones, if so which ones? Bushes, Original or Poly, if...

Anyone know where I can get a Parts catalogue/manual for a Disco2 TD5 2002 model? Cheers

Pretty much hits the nail on the head :D :rolleyes: Well suppose you had to get that one in :D

Fanatic has actually pointed me in the right direction. However I do now think I could have worded it a little better. :doh: You're absolutely right fixing the fault is more important than just clearing the the fault code. Reading the threads about the "three Amigos" has cleared up a few...

OK Cheers

Do any of you have any experience with the Nanocom or the Bearmach diagnostic kit? I have a D2 TD5 and often get the dash board turning into Xmas tree lights (well ok the ABS, Traction control & the Hill descent lights). I've taken it into the garage each time and it's turned out to be a...

The original post was about the door bottoms the steel frame has pretty much gone. The Ally skin is fine, but the thread ended up moving on to door tops, Which I also need to replace. There I hope that has cleared it up for you. Any way I have found some repair sections for the bottoms so...

Yup I'll agree with that. Cheers anyway, something to think about when funds are more available.

Other than Ebay, any suggestions as to where I might be able to get some military door tops? :)

I've been drooling over the Rocky Mountain tops for about the last week now, just can't afford them right now. But I didn't know the military ones were alloy :o

Cheers :D Thats another question you lot have cleared up for me. Most appreciated, I think I'll have a good look at Paddocks tonight.

I'm in the process of rebuilding an 88" S3 pick-up. I've pretty much got how I'm going to proceed sorted out in my head, except for the doors. Both tops are shot, so I am going to replace them. The Ally skins are ok, but the steel frames are corroded in the corners and not offering much...

Cool, Cheers for that :D

Thanks for that. At the moment I am rebuilding this swb pickup, having all the other work needed on it to do. I really didn't want to have to swap an engine right now, I just wondered what could be done with the original engine to get a little more power out of it. At the end of the day If an...

So thats pretty much it then. No tweaks with fuel pump or timing etc. (I don't know so thats why I'm asking) Cheers for all the input though :)