Recent content by ScottyNinety
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
-
Good info, thanks all - visited the SKF/Speedi-Sleeve website this morning - brilliant solution!
And I have all the remaining key ingredients...hammers, bit of pipe, brute force and ignorance (plenty) - what could possibly go wrong?
-
Good advice, thanks - had never heard of these before now.
-
Thanks for any advice on this one people....
Reassembling front axle and one of the half-shafts has a little surface corrosion and pitting on the machined oil seal face as per the image which I hope shows enough detail.
Is this fit for purpose or should I get it machined or turn in a lathe...
-
OK, thanks - good advice and will need the 54mm radius arms in that case if I understand correctly?
-
Thanks very much - just posted my first question, looking forward to help from the LR community!
-
Thanks - looking forward to some advice!
-
Thanks if you can keep me right before I refurb a Disco 1 axle for Defender use - it's a 24 spline non-ABS which I believe came from a mid 90's 300TDi. Some differences with steering linkage set up between Disco 1 and Defender (I think? Steering damper location being one of them) but generally...
-
Hello people - registered a while back but project went on hold but will be needing some help, thanks in advance for all assistance.
Bought a really sick RRC 3.9EFi and 4spd ZF a few years ago and gave it a full rebuild as a winter for a keep me out of the house kind of project. Plan was to...
-
.....coz if it does I can’t find it?
Two hours later;
****Hang on ..... found the for sale section - original post deleted and will put back in the right place****