Recent content by sausage

Great thanks stan

cheers zed ,the standard rear spring is in fact very close to the specs of a cobra 2 inch lifted HD coil here in NZ

Ive searched the crap out of this and have no luck finding much, seems to me i can use a standard rear coil on the front of my d1 to lift 2'' ,anyone done it ? cheers Andy

I've got the accuspark in my ducellier ,and they are excellent no problems in 5 years

Yes its a duce dizzy ,can't help with plugs, I've used champion rn11yx or 12

Hi there the duceiller dizzy has the condenser on the outside of the body, as for CR the head has a raised section on the manifold side between the two centre outside head studs ,this would be stamped 7 or 8 ,or if its an earlier engine there is no raised section and would be low compression.

Yes + to red - to black ,the ballast resistor is a ceramic rectangle shaped thingo on the bulkhead needs to be bypassed

Try putting a very small rubber band under the rotor to raise it

https://www.youtube.com/channel/UCzjS_6kYzuWNznwIfQdqt1w

I had the same symptoms on a Datsun a series engine ,after a head gasket replacement similar noise ,I replaced the head gasket, retourqed and set clearances and never found any problems ,the noise was gone after the second go at it ,weird

I've been running tubeless tyres ,with no tubes on rivited series rims for a while with no problems, air down off road ,never popped off ,haven't had a flat tyre ever, was always getting flats with tubes because of the quality that is available is no good these days

I'm running tubeless tyres on 5.5 in 109 tubed rims no problems ever, have deflated them off road never popped off

Easy to fill via pulling out the short side 1/2 shaft on a jack stand