Recent content by Russelljwatson

Hello, I've tried all of the door switches. They all seem to be fine, even when they are disconnected the lights stay on. When the doors are closed the switches are open circuit, so I'm assuming I have a short to ground somewhere (I doubt it though as there is no flickering of the bulbs. They...

hi guys, really need some help! When the doors are closed on my disco the interior lights keep flashing constantly. When the are set to auto and the doors are closed and engine running they still stay on. Anyone have any ideas bar taking them out? The ring around the ignition block also stays...

Thanks for all the advice guys. Got a set from island 4x4 in the end

Ok, thanks. I'll try the other suppliers. Only think I don't like about paddock is they will charge me £7 delivery I expect!

Hi, according to paddock spares the britpart are oem?!?

Hi all, Can anyone help? I need a new set of pushrods for my 300tdi disco. Does anyone have experience with the bearmach ones or should I go with britpart? Many thanks in advance Russ

Cheers! I found this one on paddock but it said something about non egr! I though all 300tdi's had egr?!?

Hi guys, do any of you know the part number for the water temp sensor that is in the head, just below the stat? Cheers Russ

Ok, thanks for the advice mate, I'll have a good listen over the weekend!

I thought as much, sounds like its coming from both sides. Is there anyway to tell which side it is without taking them apart?

Help! Hi guys, I've got a click noise coming from the front end when I put it on full lock or almost full lock, left or right, going forwards or reverse, any ideas what may be causing this and is it likely to be safe to drive?!?

Yeah, my vin starts VA. the shaft was for LA and on. The only thing I can think of is they have sent the wrong one, will have to wait until Monday now for them to open!

Tried that, it won't even start to locate. I've held it up against the spline on the old one and it is quite a bit ( around 2mm) smaller! Thanks for the suggestion though

Hi all, Got a bit of a problem, needed a new steering shaft for my 97 disco 300. Got one from paddock, a britpart QME500040. Took the old shaft off today but but new shaft won't go over the splines! Anyone had this trouble before? They don't even come close to fitting let alone being a bit...

23/24 round town, 30 @ 70mph long run and 36 @ 60mph on a long run. Standard disco 300tdi auto edc with 235 75 at2's