Recent content by Rubberknees
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
-
Pop into a shop, buy a bottle of cold water and pour it over the top of fuel injection pump. Over heat sensor just under cover and can stop it firing when too hot. water trick can cool it down enough to make it fire up
-
It may be running but is it making any air. If the piston seal is worn you will get very little pressure.
-
have a look i technical archive for Wammers post on checking compressor. It could be duff
-
I got one for Rangie and mx5. Play what I like and no ads like the radio:D
-
-
+1 its an easy job to by pass under bonnet
-
Try Youtube sure there's a couple of videos
-
-
The black electrical rectangular thing bolted to side of valve block
-
If mine was the original its 25 years old, so not done badly
-
4 shraeder valves . I keep a set in a little tin in the boot for just such an emergency. Never had to use them since I bought them YET;)
-
For a week or so old gals been a bit hesitant on pulling away especially uphill. Cut a long story short narrowed it down to MAP sensor. Had a discount code for the bay so ordered a brand new one for £27. Fitted yesterday and the difference is just what the doctor ordered. Now quieter, smoother...
-
I used something similar off the bay a few years back. Did improve it
-
And then
Drawing curtesy of or good friend @saxavordian
-
Well done. Never say die 👍