Recent content by Rob90

If you're looking for a set of mud tyres to put on separate rims then either go for Anacondas from Greenway/Colway or Maxicross from Simonnites. Unless you want to spend stupid money of course and then you might as well go for Simex

Hey all :) We've discovered a few Freelander accessories in the garage that were took off before the car went back so I'm looking ot get rid of em. We've got a loadbed/boot liner in good nick and a set of sidesteps going as well. The bits are from a 53 plate car. We're up and down to...

Thanks Matt, already printed off the linky you put up.

I've just seen the other threads on this subject, ignore this if you like :D

I've got a 1996 300tdi Disco with electric windows front and rear. The problem is that the rear windows decide themselves when they want to work. We opened them yesterday when we left Oulton Park because it was roasting inside but 10 minutes down the road they refused to close resulting in a...

:d

One place you could try is Christian Autos in Bristol 01179 601443

Might be on about the lift pump ?? Where abouts in the engine bay is it landylady??

You'd better hope its the wiper motor because replacing the worm drive and spindles is a horrible job, all the top shelf of the dash has to come out and usually involves a small amount of swearing when getting the spindles out. Good luck

The motor is located behind the dash on the passenger side at knee level, you'll have to remove the corner section below the grab handle. Disconnect the linkage spindle from the motor and replace the fuse and see if the motor turns. If it does the it sounds as though the linkage needs some...

PM sent paul

Yes Paul, I was going to put it on ebay as soon as soon as the pooters up and running at home. It a 109 canvas, complete with hood sticks and all fittings to go around the cab and windscreen. I bought it brand new and have only had it on a couple of times. If you're interested i'll have to...

Landranger 146 and 147

I've got a 109 canvas in green but that's not much help I suppose :D

Or there is Mayborn Engineering at Brislington near Bristol