Recent content by Reggaerover
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
-
R
Yeah I found that one to later my post but I have ordered one on paddock Spares.
-
R
Okey good to know if the sensor doesn’t work I try it like this and inform the new owner of the d2 thanks for all the help!
-
R
Yeah the car drives completely normal like before but now just with the Amber ace light on the dash, no oil leaks or anything the reservoir remains completely full to the Max so it is weird.
-
R
Yeah if the sensor doesn’t fix it I guess I try to sell it with the light on and tell them about it.
-
R
Not 100% sure but I cant figure out what else it can be so I hope this is it. Its the ace pressure transducer. Located on the side of the ace valve block
-
R
Is there Any possibility to just deactivate the ace system without messing with the Safety of the car? I was just about to sell the d2 and now the problem shows up. I looked to order the sensor but that is 150£ without sending and I live in Belgium so that may take a long time or cost to get here.
-
R
So there is serieus fluid activity in my reservoir at idle so does that mean the pump is good ? I Will order a pressure transducer and try that first. Is it possible to take out the filter without losing to much fluid? Otherwise I have to order an extra can of ace oil too.
-
R
I did see that the pressure is only 13-14 bar, maybe I should clean the filter or is that useless in this case ?
-
R
So I put a bridge on the ace relais and now I do have readings. I put the pictures with the reply. My disco is a 2003 facelift indeed
-
R
Hi,
The orange ace light is in my dashboard. I have read the faults with my nanocom and it reads ‘pressure signal out of range’ and ‘hydraulic pressure to low’. My first guess is that the pressure transducer is faulty. I tested the input too On the nanocom and all the pressure measures read...
-
R
Ok! Thanks for the help :)
-
R
So srs light is away from the dashboard after placing the other Rotary coupler. I did notice that the fault on the nanocom stays there but instead of ‘permanent’ it became ‘intermittent’. Anyone knows why ? Can’t delete it so thats weird. For MOT I think i Will be okey because the srs light is...
-
R
Thanks all for the help! I ordered a Rotary coupler so hopefully that Will help the problem!
-
R
Cool i didn’t know there was a tester for it! I think it is the Rotary coupler because yesterday i tested a spare airbag that my brother had. The fault is still there so it seems almost not possible that 2 airbags are faulty. I have ordered a coupler so when that arrives i test that. Thanks for...
-
R
Hi there!
I think that yellow cable under the Seat is from the seatbelt pre tensioner and not the airbag :) or am i wrong ?