Recent content by Redsunsuperman666
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
-
last time i washed mine the clutch went so not washed it since that was 2 years ago lol
-
did you ever get to the bottom of the problem and were there any other fault codes
-
Hiya
i have noticed that not all the copper washers i buy are exactly the same so you might be right i will get some genuine ones.
cheers
-
Hi Everyone
I have been having issues with my 2.4 td4 2007 Defender for a bit now and just cant seem to get to the bottom of it so any suggestions or help would be appreciated.
I will attach some pictures of my injectors but they are really bad and i only had them out a month ago to clean and...
-
how come mine is not listed
-
Does anyone know why my transfer box has this number 81D169469G TIA
-
Sorry to jump on this thread but i cant find an answer anywhere else, my transfer box number is 81D169469G and cant find any info at all, any ideas
-
Hi Everyone after a bit of advice and thoughts on the oil product attached.
After doing a lot of research and spec checking i am thinking of using this oil in my front and rear diffs, transfer box and gearbox as per the spec and product profile it seems to cover the lot 75w90, GL4 and GL5...
-
Hey bud what size tyres are on those metal rims?
-
I have recently replaced ALL the ball joints and bushes on the front lol including the one on the drop arm with the circlip and thats was a bigger itself im using bearmach for everything now thanks for the help
-
Hi everyone,
Is it possible to change the lower seal on the steering box whilst its on the vehicle?
I have all the tools including the arm remover plus the seals and ACE replacement fluid.
Thanks
Mark
-
So looks like i have found the size.
The approximate hole sizes are 30 mm and 16 mm, Uncompressed height 26.5 mm.
Landrover Fit Landrover Defender and Discovery 1 steering joints. 2002 Freelander Front Ball Joints. Land Rover Series III track rod ends.
Fit anti roll bar links on the pre 94...
-
Haha marjon i know but im saving my money for when the chasis needs welding
The old one is f#$@÷d so wont measure correctly.
-
The whole kit on lrparts is only £2.50 but i dont need to replace the ball joint just the cover 5 minute job
-
I have a load of spare dust covers all different sizes all the parts i have looked up on line are correct but they dont give the dimensions i knows its only a couple of quid but i would rather not buy a new one when i have others laying around