Recent content by redshark

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
  1. R

    HOW TO re configure ECM with nanocom

    Hi thanks for all your input SIERRAFERY MUCH APPRECIATED.
  2. R

    HOW TO re configure ECM with nanocom

    Hi just an update to the immobiliser problem replacement ECU cured the problem thank you.
  3. R

    HOW TO re configure ECM with nanocom

    OK THANKS VERY MUCH FOR YOUR HELP WILL TRY A DIFFERENT ECU .
  4. R

    HOW TO re configure ECM with nanocom

    Hi i have followed your instructions it learns security code no problem then went to set alarm to not fitted and started engine just the same 2 second run do you think it is not getting the signal from the BCU to the ECU IF SO WHICH WIRES SHOULD I BE CHECKING FOR CONTINUITY THANKS.
  5. R

    HOW TO re configure ECM with nanocom

    ok just an update got nanocom out again this afternoon and managed to get into ecu and it says ecu imobilized does that meen it is caput look forward to your replies thank you .
  6. R

    HOW TO re configure ECM with nanocom

    ok will do that this afternoon when get back from work tried quickly the other night but could not get into the ecu only bcu and every thing seemed ok in there thank you col.
  7. R

    HOW TO re configure ECM with nanocom

    Hi thanks for the info i dont think it is imobilzed it starts and runs for a second or two and then stops and you have to lock doors and unlock and then it will start and then stop again we have tried with the eka code but just does the same thing which pins on bcu to ecu would you check for...
  8. R

    HOW TO re configure ECM with nanocom

    HELP NEEDED ON HOW TO RE SYNC BCU WITH ECU WITH NANOCOM IF THAT CAN BE DONE AS IT HAS IMMOBILISER PROBLEM.ON MY DISCO 2 TD5 2000 .
  9. R

    Hi looking for help in finding out how to check continuity of wires from BCU TO ECU for...

    Hi looking for help in finding out how to check continuity of wires from BCU TO ECU for immobiliser which pins to check thank you.
  10. R

    Hi redshark here new to the forum in need of your expertese.

    ok thanks for the reply will have a look ans see if any one reasnably close to me thanks Col.
  11. R

    Hi redshark here new to the forum in need of your expertese.

    Thanks for the reply i see there is someone on ebay that hires them out that might be the way to go thanks Col.
  12. R

    Hi redshark here new to the forum in need of your expertese.

    Thank you for the welcome. just a bit of an update to my quandry the disco asksepts the eka code but still cut out 2 seconds after starting and also forgot to mention the rf receiver as been replaced with a knew one as the dreaded water got...
  13. R

    Hi redshark here new to the forum in need of your expertese.

    Hi looking for some help with my discovery 2 td5 Hi having problem with my disco 2 td5 2000 model,my problem is after starting the engine cuts out after 2 seconds,we have had the bcu away to turner diognostics and all is fine the disco locks unlocks with key fob emobliser light goes out heater...
Back
Top