Recent content by RangieKev

Hello, I am looking for some advice with regards to changing my p38 back to air suspension, its currently on springs, which is how I bought it, but think about converting back for more ride comfort, Has anybody done this or am I opening up a can of worms?

Sorry for got to mention that, its a '95 dse

Hello, I wonder if any body can tell me if it is possible to get clear button in the heater control unit as mine are all green plastic and have changed all the bulbs behind the clock, lcd display and the other buttons to blue to match my head unit. Thanks

Hello, I am looking for advice/recommendation as to who people use for gearboxes, I have a P38 Range Rover dse manual and the input shaft has sheared, now looking to buy a box this week for it. I have been recommended Ashcroft Transmissions by a few people and I have found Thornton...

thanks for all the help, I took the risk of only fitting a clutch kit and it seems to have paid off, got it back on friday and was running sweet as a nut until one one the belts snapped tonight. :(

Using my on board computer I have averaged 39.8mpg on a trip I did from glasgow to shropshire and back, total of 660miles, on the motorway i sat at 70 the whole way on motorway and did 100miles of the journey in the countryside. Normally the computer says i average 31mpg and that is usually hard...

Yeah they sure were, I got quoted £450 for the flywheel alone, so I have taken the risk of just fitting a clutch kit and I am hoping it all good, found out got a hole in the exhaust to so new centre silencer too! :(

when you say limits, do you know what the limits are and how to check?

ok, do you know what the cost of a new DMF shall set me back?

Is this a common thing on these to go?

Hello, I dropped my Rangie off at the garage this morning to get the clutch replace as i had the usual syptoms of a slipping clutch. When u got to the garage after work I got a thumbs down and the jeep was still 5ft in the air on the ramps, after inspecting the clutch plate there was very...