Recent content by PETER PETRAKIEV

And the end result. :)

Let's move the topic a bit, I hadn't done anything in a long time, kind of like daytime running lights.

Yes, was working, it was necessary longer to hold the button! ..... until fluid flows through the valve, and the cistern remained empty. :(

A few pictures it might be useful to someone. Disassembly sucks, the membrane of the new valve is very hard and does not work!

The next mission: - removing the windshield washer reservoir. - Leakage from check valve, highway for rear window.

And a dissection of the sensor. :) :mad:

Mission accomplished, replacement of - ABS Sensor Front - STC1749. STC1749 - Sensor - Wheel Speed - Front Wheels - ABS Discovery 1, Defender. Attention: - if you don't have oil seal ABS - (25) -remove only the sensor, do not take out sensor bush ABS - (26) you'll break the gasket !!!

Yes, that's how it's taken out, I hope it turns out like this. Not an air gap, the cable is broken. .... I will buy a new one.

Guys I need help. How to remove the front sensor of ABS Discovery 1- 300Tdi ? Is it just a pull out or develop both bolts on top swivel pin. .... if there is a topic with pictures how it's done I will be grateful!

Error !

Look here too, there is a picture: https://www.landyzone.co.uk/land-rover/my-project-land-rover-discovery-300tdi.171282/page-14#post-2873086

Writes only, 3 Ton Heavy Duty Steel Ultra Low Profile Floor Jack Quick Pump Lifting Car - lifting range - 75-500.:( ....I threw the box away.