Recent content by peaky1979

It has 3 wires going to the plug but there red blue and green now when i got the car they were black red and blue and the black 1 was disconnected so i replaced the whole lot back together but like i say the obd reader doesn't pick the fault up

Its a 2006 range rover sport hse 2.7 tdv6

Hi mate it doesn't move at all it just stays the same fully down. I have done a collaboration myself as my obd reader does it but it never comes up with a code for the sensor

Just noticed again thats what i said rear passenger wheel in the first message 🤣

Yes sorry i just noticed i said right 🤦🏻‍♂️

I just copied what the last owner had done

I have tried that. The last owner had replaced the plug and 1 wire was hanging off so i got a new plug and sensor but not sure if the 3 wires are the right way around

Ive also put a new plug on but its still the same. The suspension works fine it just goes down every night but if i disconnect the battery it stays up

Hello mate Yeh its not recognising it. On the 4x4 screen its permanently down. Ive done a calibration on it with my computer. Thanks

Hello everyone Does anyone know the proper part for the rear passenger side wheel height sensor. I had 3 off amazon and it still wont read on the 4x4 screen Thanks Steve

Done that multiple times and it doesn't move it stays fully down on the screen. The other 3 work on the screen

Hi mate thanks for your interest. I got the sensor off amazon as it said the left rear sensor. It all fits correctly. I done the calibration with the measuring tape and they are all spot on just cannot get the light off the dash as for some reason my fault reader wont let me into the ecu even...

Hi mate i have done that myself with my fault reader. Funnily enough tho it doesn't show any faults for the suspension on the reader. All the special programs work fine.

Thanks for the reply mate. Yeh all tyres are inflated and holding air.