Recent content by Parkheadlad
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
-
P
Managed to source an engineer who knows the V8 engines well and is willing to work on my engine. Attempted to drive to his workshop (20 mins from home) but after 5 mins engine overheated again - limped back home after waiting a while for it to cool down. Call me a pesimist but my worry is if the...
-
P
Could have slipped liners (by doing some research - steep learning curve but still dont know what they are/do but I know it's not good) - there is a tapping noise which starts when the engine has warmed up and increases with engine revs - this seems to point to slipped liners.
-
P
Just picked up my rangie today after talking with the mechanic. He suspects a blown gasket. He phoned up the local landrover dealers and they said the 4.6 is prone to overheating and may have warped the engine block - they suggested a new engine as replacing the gasket may not solve the problem...
-
P
Put her into the garage today - phoned up and the receptionist said he was waiting for fluids to arrive - phone back tomorrow....the plot thickens!
-
P
Thanks Sandyt for your thoughts. Thought I would take her out for a drive to see if it would overheat again. Made sure I topped her up with water. After about 10 mins the needle suddenly shot into the red and the light came on - it was rock solid at 12 o clock up until then then bang, straight...
-
P
Wish I had the expertise and (I assume) facilities as you sandy. My 2000 4.6 encountered massive over heating last Thurs with major coolant lose - booked in to local garage to sort the problem (assume blown HG). Would you have any idea of roughly what costs I am expected to dish out? Beginning...
-
P
Had the same problem - bulb failure warning, tapped the rear unit - light back on but annoying bulb failure warning still there. Any way to get rid?
I can tell you what my RR will be doing on Wed - local garage for (almost certain) new HG.......OUCH!!!!
-
P
Will check the obvious today - booked into local garage later in the week. Thanks for the advice - will update.
-
P
Thanks for the quick replies. So a previous owner decided on a quick fix. Are these HG sealers worth trying (or does my situation answer that question).
-
P
Hello
Arrived home today and as I parked my 4.6 2000 p38, I could not help but notice there was steam pouring out of the engine...cue head in hands! Temp gauge was flashing red. She has done 126,000 miles and as a consequence of being a regular visiter to this (excellent) forum and reading many...
-
P
First of all thanks to Datatek for providing me with the all important EAS cable and software. Did the initial simple checks as suggested by Wammers but all ok. She stays rock solid overnight in terms of height.
I have attached the fault readings from the cable and the software programme - the...
-
P
My P38 2000 4.6 has started to spew out coolant all at once - usually when i switch off the engine.........it leaves a significant puddle! It forms at the front on the driver's side - could be wrong but it does not seem to be coming from the radiator - I havn't had time to have a good look. Any...
-
P
Thanks lads. With ref to Saint V8, is this something I shoudn't worry about too much as I run her mainly on gas - only use petrol on start up when she can run rough.
-
P
P38 4.6 (LPG) 2000 runs a bit rough when on petrol but ok when I switch to LPG. Thought it might be a fuel filter problem but found out from this forum that it does not exist! So why does ebay have sellers selling fuel filters? Any other reason why she is running rough on petrol only. Changed...
-
P
Replaced the air flow meter but still having problems - again when starting up and pulling away. It hesitates and threatens to cut out but then picks up at the last minute and then ok. The RR has a LPG convertion - it starts on petrol - could it be a fuel delivery problem?