Recent content by Not Without a Light On

:)Solved:) With a £192 diagnostic and 2 days being quoted with The Landrover Dealer, I thought I would try one more thing. Turns out it was the bumper cable. I did change all 4 of the sensors as well, as I don’t want to have to take the bumper off again. The middle connector on the cable is...

Hi Yes, Not a Landrover Stealer one. My iCarSoft one wouldn’t even recognise the Parking module. The autoelectrians (Halls Electrical) put a read on it to diagnose the parking sensor out and tested all the cabling. Unless the Parking Aid module I tried was also not working, then I am kinda...

Hi All, On my Disco 4 (13 plate), I have a camera feed fault. See the embed below. If you can’t see the media, it is a bad feed sort of picture, but the unit works fine for all other features, such as radio and normal LR functions. I have currently changed the camera for a new one (£300+ for...

Hi, Did you get to the bottom of this. I have the same. Have got a new camera (New LR Original), I’ve checked the rear window lock loom and had an auto electrician check all the wiring. Currently have the head unit in for inspection, because I refuse to pay out £800+ for a new touch screen. Have...

Definitely beating the crap out of the Disco and spending the price difference on a dealer repair on beer x1,000,000

So, Bearing replaced. My pointers. I got the hub nut loose with the wheel on and the logo cap off. I tried loosening with the wheel off and someone on the brake, but it wouldn’t budge. Eventually got it loose (and yes I had unstaked it) with a breaker bar and a piece of pipe. Then the rest was...

Thanks I have the D4 workshop manual, it just doesn’t give the Tools required and a couple of the videos online have some very different Torque settings. Frostythor has reinforced the 230nm for the Wheel retaining nut and I know the brake calliper ones are the higher with 275nm. So I’ll have fun...

Perfect thanks. I did think 350nm, which someone quoted was a bit steep. I was already wondering how long my scaffold pole would have to be to get the leverage.

Yes, whole assembly. I’ve found it’s easier on most vehicles to replace whole assemblies these days. Plus I get to bash the disco with a hammer for a purpose, instead of just thinking about it

Lynall, Thanks. I might just have to be careful with the hammer if the sensor is stuck. I need the truck back on the road quick-ish, so I’ll probably just stick to the hub at the moment, as I’m more likely to swear at it and drop something on my foot changing shafts.

Dear All and thanks in advance, Had a bit of a intermittent hum/rubbing noise with a slight rumble. Thought it was near side front, but after jacking up the front and spinning the wheels, the Offside front is rumbling and has play on both the 3/9 test and 12/6 movement check. I can see the...

Thanks, The pit falls of being new. Thanks, seen these, but wanted something a little lighter and the Disco isn’t really left anywhere long enough to have a good go at the spare (if they want). Just wanted something that stops someone snipping the cable in a few seconds. Thanks again

Dear All and Thanks for any advice in advance. On my Disco 4, 3.0 HSE, I made the usual mistake of winding the spare winch up without the wheel and hey presto, new winch required. I am also adding the LR anti theft device, however am a bit stumped on exactly how it installs. The LR part is...

Sorry, thought It might show on the left under my name. Discovery 4, 2013, HSE 3.0

Hi All and Thanks in advance. Just dropped the spare wheel and made the usual mistake of winding it back up without weight, so replacing the winch. I also got the LR112834 kit to deter any scrotes (If they want the wheel, then they are gonna get it eventually). However, I’ve no idea how it is...