Recent content by nigelrw
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
-
hello mozz smith - you are my last best hope - 2001 4.6 P38 in lock out - have tried to enter EKA code but red light keeps flashing and alarm goes off if i turn on ignition after - I am open to all suggestions - I did allow battery to go flat but is now fully charged of course key no longer work...
-
Just rebuild suspension air compressor all working fine next job to drain and refill gearbox
-
Thank you all for your input and fashion sence !! I think way forward will either be to make up panels or get hold a body and cut out the part need which is somewhat more economical than buying two side panels once again many thanks
-
Thanks Saint.V8 - so far it looks like no repair panel but waiting on some suppliers to get back - can get the "side of the car" from LR for approx. £1.5k - looks like getting under and having a poke around to see just how serious this could be
-
My son's L322 is in need of new outer sills o/s & n/s on his 2004 3.0D - Having spoken to our local Land Rover dealership I am recovering from news they can only supply side of car rather than a repair panel and after trawling web I am no further forward- has anyone had to replace panel and if...
-
Replaced throttle body cooling plate and cleaned throttle body - job I have been meaning to do for ages - now to give the car a good clean inside and out
-
Datateck - it seems you are havinga rough time with your P38 sorry to hear this- try the link below
Heater Core O-Ring Replacement
I found this very useful - got extra set of "o" ring just incase & changed the temp sensor - that said I did cut out the air duct and put back with duck tape to...
-
Many thanks for pointing this out
-
Thanks Stufer - I replaced presure switch when I rebuilt valve block just in case should have said sorry
-
P38 2001 4.6 100k - The EAS system has been giving me some worries recently -I have replaced all four bags (leak on rear) and rebuilt valve block and compressor - system works well with no dropping down over night and from access mode she is up to correct hight within 15 secs so all seems fine...
-
I too had same problem on a late 2001 4.6 - check your little red light flashes when you press button - put key in drivers door and press and hold down lock button - still holding lock button turn key anti-clockwise to lock door but hold it there for at least a slow count to 10 - you should hear...
-
Thank you for the idea that the storage side could be at fault will check tank and pipework just in case :)
-
Many thanks for the replies - will clean connectors first and if no different looks like the pressure switch
again many thanks
-
Please some advise - but I must let you know actions taken thus far - some weeks ago the EAS pump seemed to be working overtime but not going into fault - suspected leak but could find none - bags looked to be original so started at that point and changed out the four of them for new Dunlops...
-
Good information sas1810 - I will have to do this - have some stainless steel mesh on order - will take pics and post when job done