Recent content by Nicktrackside

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
  1. N

    P38A rear quarter glass removal

    Remove with a sharp knife or a sharp chisel. Might have to have a new trim. You may need to get a windscreen company to replace it.
  2. N

    Windscreen adhesive

    Somthing like this. http://www.frost.co.uk/black-windscreen-sealer.html You don't want the stuff used the fit modern bonded glass.
  3. N

    Nasty looking defender crash in Powys

    What ever happened, what great work from all the emergency services.
  4. N

    Rrc windscreen seal replacement

    Try warming the new rubber in a bucket of hot water before fitting.
  5. N

    Defender Rear Door Glass?

    You should be able to buy the glass from any windscreen firm, not sure if the trade surpliers will sell to the public. Not sure about shipping, could you pack it yourself to send.
  6. N

    Air Con Condenser replacement

    Could try Pirtek.
  7. N

    Throttle body heater

    I replaced it once, then when it started leaking again I just bypassed it.
  8. N

    Alaska off road warriors

    It started on the History channel last night.
  9. N

    seat belt buckle

    Not available new anymore.
  10. N

    help please temperature issues

    I had the same thing after I replaced the expansion tank. It only stopped after slowly undoing the cap every time the gauge went into the red, only enough to get the coolant to fill the tank. I guess it had a air lock somewhere.
  11. N

    Super-luxury Range Rover SVAutobiography - Official

    If I had one, would it be better to drive it or sit in the back?
  12. N

    Solar charger advice

    Do solar chargers work if left inside the car? I ask because the glass is UV reflective?
  13. N

    CV boot gaitor replacement

    Don't replace the drive shaft nut with a Britpart on as it is 36 mm. A 36mm socket won't go through the wheel.
  14. N

    What did you do with your Range Rover today

    The axle nut was not a problem after i knocked the stake nut out of the groove in the axle. I am blessed with a body designed for jumping on the end of a long breaker bar. the hardest part was removing the hub after I had unbolted it. I managed to loosen it by knocking it around until one bolt...
  15. N

    What did you do with your Range Rover today

    Replaced the front wheel bearing and hub on my P38. Only took about 2 hours. I was putting the job off for ages, but MOT time so it had to be done.
Back
Top