Recent content by Mellbell

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
  1. Mellbell

    Disco 1 300tdi.

    Does anyone know where I could get a 1 full harness. 2 srs harness with it's original ECU. 3abs ECU. have no part numbers in a bit of trouble.
  2. Mellbell

    Hawkeye and SRS on 300 Tdi Auto (Distributed SRS)

    Got the same problem.been trying to do it on mine. How did you wire yours up?
  3. Mellbell

    SRS and ABS Light Removal

    Any chance of a run by how you actually did it.PLEASE👍
  4. Mellbell

    Disco 1 300

    Lt230 transfer box. On the bench input and output flanges If you rock the front one way and the back the other way how much play is acceptable.just renewed the centre diff !
  5. Mellbell

    Disco 1 lt230 box.

    Does anyone have a tool lrt-41-005. It's for the input shaft to set the pre load. Any help would be appreciated.£££££.
  6. Mellbell

    Collapsing spacer

    Does anyone know where to purchase a non collapsing spacer for t/b
  7. Mellbell

    Discovery 1 300tdi

    Anyone have a r380 suffix j type55a manuel gearbox to fit onto a disco 300tdi for sale
  8. Mellbell

    Disco 1 300

    From automatic to Manuel. Does anyone know which model gearbox I should use for this conversion.i know it's a r380. And with having 31inch tyres on should I change the ratio in the t/box.
  9. Mellbell

    Disco 1 300

    No gearbox on been renewing rear crank seal. Would it be ok to start and let tick over to check seal ok.dont fancy it leaking.
  10. Mellbell

    Disco 1 300tdi

    Swapping automatic box for r380 box.would my transfer box be ok to use or would I need another. If so what t- box would I need what ratio. What has other people used. Cheers.
  11. Mellbell

    Disco 1 300

    No not that it won't slide on till that point the pin and bolt holes line up.it sits on the very end of crank can't get it any further.
  12. Mellbell

    Disco 1 300

    Here's a one for the experts.n reg import. On changing auto box for Manuel. Renewed rear crank seal.brand new fly wheel holes all line up but a can't get it to fit crank.not slagging any one off so am not after that.but is the fly wheel to be that tight don't fancy damaging it.is it me or is it...
  13. Mellbell

    Disco1 300

    Automatic box changed to Manuel r380 box. Do I need to change gearbox cross member or not.!
  14. Mellbell

    Disco 1 300.

    Has anyone had problems with putting new fly wheel on. Removed automatic box for Manuel. The tolerance on the crank and center of fly wheel are really close.
  15. Mellbell

    Disco 1 Rear crank seal?

    Fitting a new rear crank seal disco 300tdi. Does most people only use a gasget.or rtv.or both. Don't want to f up. Cheers
See more
Back
Top