Recent content by Megamagelol1

Thanks for the reply guys new MAF on the way

Hiya mate yeah Im just wondering why it’s now thrown codes back up for 02 sensors, or if the Maf is no good would it show those codes. I’m going to clean Maf and replace o2 sensors and go from there I think

right little update ive unplugged MAF took her for a spin and seems loads better revving nice all the way through the rev range. got home and reset the fuel adaptive values plugged the maf back in and these are my findings: very interesting! no running lean fault codes this time but these ones...

thank you for the reply mate, readings for emmissions were: lambda fast idle test - limits 0.97-1.03 actual 1.06 second fast idle test limits 0.97-1.03 actual 1.15 everything else was fine. its the load air that stuck out to me to be fair i cannt find on RAVE what its ment to be or that was...

Good afternoon guys and girls, I noticed today that my 2001 range rover p38 4.0 thor was fine up until 3000rpm but then really struggled. got home plugged her in and shes trown up p0174&p0171 codes now she did fail emission on her mot the other week the first time on lambda's, but the garage...

Your a hero mate thank you very much

Just checked and it was still set to air ! Ahh right I’ve now configured to coil, so shal I see if the noise continues? If it dosent I might just leave it all in place, or do you think best to remove ? Thanks mate

Hey sierra, I was gonna message you direct, hope ur well mate you helped my a while back a ace fault, took ages but turned out to be a broken wire, not sure if you remember, but hope your doing good. And with a nanocom. But I myself have a Hawkeye total, I was kind of thinking the same thing...

Hi guys and girls, I know a lot of you will be thinking, don’t do it!! I took it off a couple of years ago, as this disco is just a toy really, for the air suspension lovers though, you’ll be pleased to know on my p38 I’ve kept it and refurbed the whole system!. Right sorry back to the point...

Yeah brakes feel really really good now but yes It does drop a little when you press with engine running

Pedal is better still drops ever so slightly but might be the new pads and discs ?

All done mate was easy in the end, I was just being thick haha thank you

All it says after that is hold brake pedal? There’s no real instructions

It says refer modulator bleed procedure in instructions and continue, I haven’t got any paper work with it and I can’t find these instructions online

Hawkeye total mate