Recent content by martinni282

Hi. I just changed engine mounts in my disco Td5. After asking few owners, mechanics and seeing feedback I decided to go for Britpart as there was more positive than negative opinions... Well... All holes matched, pins are fitted into the brackets but I have some vibrations in idle speed only...

Well, over the weekend I’m going to my mate’s garage... He’s got MIG welding machine and we will try to extend fitting points so seat will be moved more to the rear when bolted back in

Ok. I will work with seat only at the moment... thanks

Hi. Yes, sreering wheel is max high position... I’m nearly breaking my fingers off the joints every time when I want to open the doors... I’m just fit in with no much movements inside... operating only top half of the steering wheel as bottom half is very close to my right knee... so I need to...

Hi guys. I’m looking to get more room as a driver in my disco 2. I’m 6’8” and its a bit tight there what is very uncomfortable on longer journeys... I have idea how to sort driver seat extending fitting points to the floor and knocking off the lock preventing sliding backwards more,what should...

I was driving and suddenly clutch failed and pedal went down to the floor... then got very hard so I pressed with force and went down again... I stopped and all fluid leaked out from slave cylinder... I went to the garage, we removed the gearbox,slave cylinder broken, push rod bent and other...

Sorry mate, newbie with land rover and there was some missunderstanding from my side. Front springs were fine

Update... after so many checks ( airlines,valve block, swaping connectors/wiring in valve block) without success I put coil springs and problem solved,all straight and level now... new bushes on WATTS liks nad pivot joint,new antirollbar links and bushes... shortly after that one of rear caliper...

I think was around 140 on one side and over 150 on another side... Dave will know for sure... I was busy running with measure tape to check heights

Yes... I will look at it... suspension now is back to different levels now again even that was settled to the right measurement succesfully earlier...but at least I know that module is working fine and will look at front spring and valve block. Thank You Dave for time You spent trying to set up...

So its not the one which is responsible for self leveling? Only SLABS then?

What about this one?

Do You know where I can find a suspension module location in my disco? I can have another one to swap and check but I do not know where to find it...

Hi. I have a pnematic suspension

Anyone not far away from Heathrow with nanocom or hawkeye?