Recent content by marsie

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
  1. M

    Hi all, newbie from rotherham

    Thanks everyone for the welcome 😎
  2. M

    What did you do with your Range Rover today

    Spent half a couple hours wet sanding and buffing all the bird poo stains off the bonnet on my LSE project. As well as stripping and painting the front bumper and getting all the lights working
  3. M

    Classic LSE air suspension operation

    Thanks datatek, not sure I trust myself with electronics so may get my mate to assemble it. Can strip a landrover in my sleep but electronics are not my strong point 🤣
  4. M

    Classic LSE air suspension operation

    I am going to see about getting all the parts together to make a lead of my own that way I can carry my own diagnostics in the car until I am happy its working as it should Looking at the RSW website it looks like I will need- 5 way rists connector Serial port connector 15K ohm resistor...
  5. M

    Classic LSE air suspension operation

    Thanks Datatek, going to get alternator off tomorrow and get it tested locally.
  6. M

    Classic LSE air suspension operation

    Not sure, will check tomorrow . Its a new battery so should be good but on the off chance stuck a voltmeter across the battery and only got 12.5v max when running
  7. M

    Classic LSE air suspension operation

    Thanks guys, silly question but is there a minimum voltage to trigger the EAS to work? the reason I ask is that I checked the output from the alternator today and was only getting a max of 12.5v so that will need swapping before anything else. Just wondered if that could be a reason why my EAS...
  8. M

    Classic LSE air suspension operation

    Thanks Datatek Have found the switch in the handbook and it is to disable the eas. If the system has a fault (up and down light flashing) does the system lock out until the fault is cleared by diagnostics or will it operate if the fault is cured? If I bridge the yellow relay the pump runs fine...
  9. M

    Classic LSE air suspension operation

    Hi all, just trying to get my head around how the EAS is supposed to operate on a 92 LSE. My car has been stood for several years and when I start it I get no compressor The up and down buttons in the car both flash for about 20 seconds after startup then both light continuously until ignition...
  10. M

    Hi all, newbie from rotherham

    Hi all, I am Paul and I am a newbie to this forum. I am not a newbie to landrovers as I have owned around 60 in the past and re chassis them for a living (done over 500 chassis swaps now). I have owned just about every model of landrover over the past 30+years but currently have a 2010 Defender...
Back
Top